Security Paper Design with Frequency-Selective Structure for X-Band Electromagnetic Detection System
نویسندگان
چکیده
منابع مشابه
An attenuation Layer for Electromagnetic Shielding in X- Band Frequency
Uncontrolled exposure to X-band frequency leads to health damage. One of the principles of radiation protection is shielding. But, conventional shielding materials have disadvantages. Therefore, studies of novel materials, as an alternative to conventional shielding materials, are required to obtain new electromagnetic shielding material. Therefore, this study investigated the electromagnetic s...
متن کاملefficacy of net epoxy resin for electromagnetic shielding in x-band frequency range
results the results showed that the epoxy plates 6 and 2 mm thick had the highest and the lowest averages of shielding effectiveness at 4.48 db and 1.90 db, respectively. however, increasing the thickness was useful up to 4 mm. in addition, in a similar attenuation pattern, x-band frequency was divided into lower, middle, and upper sections. the lower section had the highest shielding effective...
متن کاملDesign of an S-band Ultra-low-noise Amplifier with Frequency Band Switching Capability
In this paper, an ultra-low-noise amplifier with frequency band switching capability is designed, simulated and fabricated. The two frequency ranges of this amplifier consist of the 2.4 to 2.5 GHz and 3.1 GHz to 3.15 GHz frequency bands. The designed amplifier has a noise figure of less than 1dB, a minimum gain of 23 dB and a VSWR of less than 2 in the whole frequency band. The design process s...
متن کاملPolarization Independent Triple-Band Single Layer Frequency Selective Structure
This paper deals with single layer polarization independent Frequency selective surface (FSS) which acts as a triple band reject filter. The two stop bands are broad with percentage bandwidth 11.16% and 10.13% and one is narrow with 3.33% bandwidth. The band ratio is more than 1.5 and band separation is around 30-35dB. This design is investigated theoretically by ANSOFT® Designer software and p...
متن کاملDesign and Simulation of an X Band LC VCO
In this paper, a systematic method for the circuit parameters design of a monolithic LC Voltage Controlled Oscillator (VCO) is reported. The method is based on the negative resistance generation technique. As a result, a VCO has been designed in 0.18um CMOS technology using a conventional VCO structure to obtain the optimum values for the phase noise and power consumption. The simulation result...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Antennas and Propagation
سال: 2018
ISSN: 1687-5869,1687-5877
DOI: 10.1155/2018/9836937