Seismic Behavior of Steel Plate-Concrete Shear Walls with Holes
نویسندگان
چکیده
منابع مشابه
Seismic Behavior of Intermediate Beams in Steel Plate Shear Walls
This paper presents some preliminary results of an ongoing research whose objective is to investigate the seismic behavior of intermediate beams (i.e., the beams other than those at the roof and foundation levels) in multi-story steel plate shear walls (SPSWs). Of primary interest is the determination of the strength level needed to avoid the formation of in-span plastic hinges, a relevant prac...
متن کاملStructural Behavior of Axially Loaded Composite Concrete-steel Plate Shear Walls
composite concrete-steel plate shear walls are the most critical resisting structural members that resist lateral and axial loads. This type of wall consisting of two steel faceplates presenting the outer skin, infill concrete and shear connectors which are used to provide the composite action of the steel faceplates with infill concrete in order to increase the strength and to reduce the local...
متن کاملSeismic Performance of Steel Plate-Reinforced Concrete Composite Shear Wall
In tall buildings the reinforced concrete (RC) shear wall is one of the predominant structural components used to resist lateral loads induced by earthquakes around the world. Previous research demonstrated that shear walls displayed a sudden loss in lateral capacity due to the wall corner and web crushing in the plastic zone. In addition, it was found that large shear distortions in shear wall...
متن کاملComparison of plasticity and stiffness of steel shear walls with composite steel plate shear wall
The steel shear wall and composite steel plate shear wall is introduced in recent three decade and is considered and is spread rapidly. Composite steel plate shear wall which is made of a layer of thin steel sheet with coating of reinforced concrete in one or both sides of steel palate is considered a third generation of resistance shear walls against lateral loads that in addition to increasin...
متن کاملBehavior of Vertical Boundary Elements in Steel Plate Shear Walls
The AISC Seismic Provisions and CSA S-16 Standard require a minimum moment of inertia for the vertical boundary elements (VBEs) in steel plate shear walls (SPSWs) to avoid undesirable VBE behaviors. The equation limiting VBE flexibility has been derived from a flexibility factor, ωt, developed in plate girder theory and the limit on VBE flexibility has been empirically specified based on previo...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Sciences
سال: 2019
ISSN: 2076-3417
DOI: 10.3390/app9235255