SELECTION AND OPTIMIZATION OF MATERIAL FOR 3D PRINTING USING GREY RELATIONAL ANALYSIS
نویسندگان
چکیده
منابع مشابه
Optimization of the injection molding process of Derlin 500 composite using ANOVA and grey relational analysis
Warpage and shrinkage control are important factors in proving the quality of thin-wall parts in injection modeling process. In the present paper, grey relational analysis was used in order to optimize these two parameters in manufacturing plastic bush of articulated garden tractor. The material used in the plastic bush is Derlin 500. The input parameters in the process were selected according ...
متن کاملOptimization of ECMAP parameters in production of ultra-fine grained Al1050 strips using Grey relational analysis
Production of lightweight metals with a higher strength to weight ratio is always the main goal of researchers. In this article, equal channel multi angular pressing (ECMAP) process as one of the most appealing severe plastic deformation (SPD) methods on production of ultra-fine grained (UFG) materials studied. Two main routes A and C investigated by FEM and compared with each other from differ...
متن کاملOptimizing turning operation of St37 steel using grey relational analysis
Nowadays, in order to reach minimum production cost in machining operations, various optimization methods have been proposed. Since turning operation has different parameters affecting the workpiece quality, it was selected as a complicated manufacturing method in this paper. To reach sufficient quality, all influencing parameters such as cutting speed, federate, depth of cut and tool rake angl...
متن کاملanalysis of ruin probability for insurance companies using markov chain
در این پایان نامه نشان داده ایم که چگونه می توان مدل ریسک بیمه ای اسپیرر اندرسون را به کمک زنجیره های مارکوف تعریف کرد. سپس به کمک روش های آنالیز ماتریسی احتمال برشکستگی ، میزان مازاد در هنگام برشکستگی و میزان کسری بودجه در زمان وقوع برشکستگی را محاسبه کرده ایم. هدف ما در این پایان نامه بسیار محاسباتی و کاربردی تر از روش های است که در گذشته برای محاسبه این احتمال ارائه شده است. در ابتدا ما نشا...
15 صفحه اولMulti-objective optimization in WEDM of D3 tool steel using integrated approach of Taguchi method & Grey relational analysis
In this paper, wire electrical discharge machining of D3 tool steel is studied. Influence of pulse-on time, pulse-off time, peak current and wire speed are investigated for MRR, dimensional deviation, gap current and machining time, during intricate machining of D3 tool steel. Taguchi method is used for single characteristics optimization and to optimize all four process parameters simultaneous...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Engineering Applied Sciences and Technology
سال: 2020
ISSN: 2455-2143
DOI: 10.33564/ijeast.2020.v05i07.050