Self-Excited Single-Stage Power Factor Correction Driving Circuit for LED Lighting
نویسندگان
چکیده
منابع مشابه
Single Stage Techniques for Power Factor Correction
Medium and high power switch mode power supplies SMPS (>500W) used in telecommunications stations are normally based on the full-bridge DC-DC converter with isolation transformer. According to the transistors states, the full-bridge converter allows four different switching sates which can be used to control the output voltage of the SMPS, and to perform the power factor corrector (PFC) functio...
متن کاملSingle Stage Single Switch LED Driver with Improved Power Factor Correction and Soft Switching
Light Emitting Diodes (LEDs) with their current performances have been proved to be the most suitable solution for street lighting applications. Nowadays, a topic of interest in this context is the design for electronic driver in order to take the advantage of LEDs performances. However, requirements such as high power factor, long life time, accurate current control and high efficiency pose ch...
متن کاملA Single-Stage LED Tube Lamp Driver with Power-Factor Corrections and Soft Switching for Energy-Saving Indoor Lighting Applications
Abstract: This paper presents a single-stage alternating current (AC)/direct current (DC) light-emitting diode (LED) tube lamp driver for energy-saving indoor lighting applications; this driver features power-factor corrections and soft switching, and also integrates a dual buck-boost converter with coupled inductors and a half-bridge series resonant converter cascaded with a bridge rectifier i...
متن کاملA single stage single switch power factor correction converter
The flyback-flyback single stage converter operated in DCM+DCM is easy to control bus voltage, but it hard to control stress of switch. We propose a new converter having low voltage stress on its switch. The flyback converter is simplified into buck-boost form. Then the PFC flyback transformer is replaced by an inductor The switch of both PFC and DC/DC stages are merged, and a diode is used to ...
متن کاملDesign for Low Power HB-LED Lighting
This paper presents an improved power quality converter (IPQC) based power supply design for high brightness Light Emitting Diode (HB-LED) low power lighting. The IPQC circuit uses a Cuk buck-boost converter to operate it in discontinuous conduction mode (DCM) using voltage follower technique for the mitigation of harmonic contents present in the AC mains current. Subsequently reduction in harm...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Nanomaterials
سال: 2014
ISSN: 1687-4110,1687-4129
DOI: 10.1155/2014/107939