SEM/EDX and XRD characterization of silver nanocrystalline thin film prepared from organometallic solution precursor
نویسندگان
چکیده
منابع مشابه
Dry and Wet Wear Characteristic of TiO2 Thin Film Prepared by Magnetic Sputtering in Ringer Solution
In this research, a thin film of TiO2 was applied on AZ91D using the method of magnetic sputtering. Microstructure investigations were done using field emission scanning electron microscope (FESEM) and X-ray diffraction (XRD). Wear resistance for the coating was investigated using the pin on the disk in the form of dry and in the Ringer's solution. After this test, the worn surface of the sampl...
متن کاملModification of Thin Film Composite Nanofiltration Membrane using Silver Nanoparticles: Preparation, Characterization and Antibacterial Performance
This paper reports on preparation of polyamide membrane with addition of silver nanoparticles (AgNPs). AgNPs act as antibacterial agents that are less susceptible to membrane’s biofouling by interfacial polymerization (IP) method. AgNPs was synthesized via green route which has been reported previously. Attenuated Total Reflectance-Fourier Transform Infrared Spectroscopy (ATR-FTIR), Field emiss...
متن کاملLaser Micro-Raman Spectroscopy of CVD Nanocrystalline Diamond Thin Film
Laser micro-Raman spectroscopy is an ideal tool for assessment and characterization of various types of carbon-based materials. Due to its special optical properties (CrN) coated stainless steel substrates. NCD films have been investigated by laser micro-Raman spectroscopy. The fingerprint of diamond based materials is in the spectral region of 1000-1600 cm-1 in the first order of Raman scatter...
متن کاملSynthesis and characterization of high-temperature ceramic YBCO nanostructures prepared from a novel precursor
As a new precursor, [tris(2-hydroxyacetophenato) triaqua(III)], [Y(HAP)3(H2O)3]; complex was used in thermal decomposition process for the synthesis of rod-like high-temperature ceramic YBCO with length of about 320-350 nm and diameters 60–90 nm. The as-synthesized products were characterized by XRD, FT-IR, TEM, SEM and EDX analyses. The results showed that by u...
متن کاملThin Film Bulge Test of Nanocrystalline Metals
Free-standing nanocrystalline copper (Cu) films with grain size around 39 nm are fabricated by thermal evaporation and characterized by the plane-strain bulge test. Young’s modulus and yield stress at a 0.2% offset are about 110 ~ 130 GPa and 400 MPa, respectively. Results show that no grain growth is observed and the predominant plastic deformation mechanism is grain boundary sliding accompani...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Mining and Metallurgy, Section B: Metallurgy
سال: 2013
ISSN: 1450-5339,2217-7175
DOI: 10.2298/jmmb120111041d