Shaft Crack Identification Based on Vibration and AE Signals
نویسندگان
چکیده
منابع مشابه
ANN-Based Crack Identification in Rotor System with Multi-Crack in Shaft
Rotating machinery, such as steam turbo, compressor, and aeroengine etc., are widely used in many industrial fields. Among the important rotor faults, the fatigue crack fault, which can lead to catastrophic failure and cause injuries and severe damage to machinery if undetected in its early stages, is most difficult to detect efficiently with traditional methods. In the paper, based on the trut...
متن کاملWheelset Condition Monitoring Based on Pass-by Vibration Signals
Apart from regular wheel wear such as decreasing wheel diameters and reduced flange thicknesses and heights, wheel flats (WF) and oval wheels (or OOR, Out-Of-Roundness) are the most common wheelset problems for railway vehicles. Within the FP7 Research Project “Saferail”, APT has developed an innovative wheelset monitoring system so-called “Wheel flat and Out of Roundness Monitoring (WORM) syst...
متن کاملWheelset Condition Monitoring based on pass-by vibration signals
Apart from regular wheel wear such as decreasing wheel diameters and reduced flange thicknesses and heights, wheel flats (WF) and oval wheels (or OOR, Out-Of-Roundness) are the most common wheelset problems for railway vehicles. Within the FP7 Research Project “Saferail”, APT has developed an innovative wheelset monitoring system so-called “Wheel flat and Out of Roundness Monitoring (WORM) syst...
متن کاملCrack Identification of a Rotating Shaft with Integrated Wireless Sensor
This paper presents a novel real-time crack identification method to determine the position and depth of a transverse open crack on a rotating shaft. A newly developed wireless sensor capable of being mounted directly on the shaft is employed to monitor acceleration at different points of the shaft in a rotating coordinate system. The vibration parameters obtained from the wireless sensors and ...
متن کاملApplication of Torsional Vibration Measurement to Blade and Shaft Crack Detection in Operating Machinery
The primary goal of the this paper is to summarize field demonstrations of the feasibility of detecting changes in blade and shaft natural frequencies (such as those associated with a blade or shaft crack) on operating machinery using non-contact, nonintrusive measurement methods. This paper primarily addresses the results of application of this nonintrusive torsional vibration sensing to: a la...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Shock and Vibration
سال: 2011
ISSN: 1070-9622,1875-9203
DOI: 10.1155/2011/460178