Shrinkage stress and elastic modulus assessment of bulk-fill composites
نویسندگان
چکیده
منابع مشابه
Changes in polymerization stress and elastic modulus of bulk-fill resin composites for 24 hours after irradiation.
The objective of this study was to investigate changes in polymerization stress and elastic modulus for light-cured bulk-fill resin composites following irradiation. Crack analysis was applied to obtain the stresses for 24 h after irradiation, which were calculated from the lengths of cracks in a glass mold bonded to the composites. The elastic modulus was repeatedly measured by nano-indentatio...
متن کاملMicroleakage of Bulk-Fill Composites at Two Different Time Points
Objectives: Microleakage is the main concern in composite restorations. This study aimed to compare the microleakage of two bulk-fill and one conventional composite at two different time points. Methods: Class II cavities were prepared in 60 premolar teeth and divided into six groups of 20. Groups 1 and 4 were incrementally filled with Grandio composite. Groups 2 and 5 were filled with X-tra...
متن کاملPre-heating of high-viscosity bulk-fill resin composites: effects on shrinkage force and monomer conversion.
OBJECTIVES To investigate the influence of pre-heating of high-viscosity bulk-fill composite materials on their degree of conversion and shrinkage force formation. METHODS Four bulk-fill composite materials (Tetric EvoCeram Bulk Fill-TECBF, x-tra fil-XF, QuixFil-QF, SonicFill-SF) and one conventional nano-hybrid resin composite (Tetric EvoCeram-TEC) were used. The test materials were either k...
متن کاملComparing the Microleakage of Bulk-Fill (flowable, packable) Composite Restorations and Conventional Light-cured Composites
Introduction and aim: Bulk Fill composites have increased polymerization depth and their contraction stress, and cuspal deflection are reduced in comparison with conventional composites. Therefore, it is claimed that their microleakage is reduced. The aim of this study was to compare microleakage of (flowable and packable) Bulk Fill and conventional resin composites. Materials and Methods: Thi...
متن کاملLong Term Degree of Conversion of two Bulk-Fill Composites.
OBJECTIVES To investigate the long-term development of the post-cure degree of conversion (DC) for two flowable bulk-fill composites. MATERIALS AND METHODS Tetric EvoFlow Bulk Fill (TEFBF) and SDR were chosen due to their distinct compositional modifications that enable the decrease of translucency during polymerization and lower polymerization rate, respectively. DC was assessed using FT-Ram...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Applied Oral Science
سال: 2019
ISSN: 1678-7765,1678-7757
DOI: 10.1590/1678-7757-2018-0132