Simple assessment of shallow velocity structures with small-scale microtremor arrays: interval-averaged S-wave velocities
نویسندگان
چکیده
منابع مشابه
Assessment of pulse wave velocity
1872-9312/$e seefrontmattera2008A doi:10.1016/j.artres.2008.11.002 Summary Measurement of pulse wave velocity is of increasing importance for assessment of arterial stiffness and risk evaluation. Different techniques are available, based either on pressure, distension or Doppler waveforms. Techniques not only differ by the algorithm used to identify specific part of the pulse signal, but also i...
متن کاملImaging permafrost with shallow P- and S-wave reflection
Shallow reflection events observed on coincident Pand Swave data from within the permafrost zone possess sufficient coherency and resolution potential to compensate conventional 2or 3-D data sets for structural artifacts related to lateral travel time variability. Reflections with dominant frequencies above 100 Hz on P-wave data and 40 Hz on S-wave data from within the permafrost have a very br...
متن کاملResolution potential of surface wave phase velocity measurements at small arrays
S U M M A R Y The deployment of temporary arrays of broadband seismological stations over dedicated targets is common practice. Measurement of surface wave phase velocity across a small array and its depth-inversion gives us information about the structure below the array which is complementary to the information obtained from body-wave analysis. The question is however: what do we actually mea...
متن کاملP and S Wave Velocity Determination
There are three general methods that can be used to determine formation velocities from full waveform logs. The first approach is to make use of the data from the entire waveform. This type of velocity analysis is performed either in the frequency domain (I.e. f-k analysis or the two station method) or in the time domain (I.e. velocity spectral analysis). The second approach is to identify the ...
متن کاملA simple form of MT impedance tensor analysis to simplify its decomposition to remove the effects of near surface small-scale 3-D conductivity structures
Magnetotelluric (MT) is a natural electromagnetic (EM) technique which is used for geothermal, petroleum, geotechnical, groundwater and mineral exploration. MT is also routinely used for mapping of deep subsurface structures. In this method, the measured regional complex impedance tensor (Z) is substantially distorted by any topographical feature or small-scale near-surface, three-dimensional (...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Exploration Geophysics
سال: 2018
ISSN: 0812-3985,1834-7533
DOI: 10.1071/eg18020