Simplified Grinding Temperature Model Study
نویسندگان
چکیده
منابع مشابه
a Simplified Model of Distributed Parameter Systems
A generalized simplified model for describing the dynamic behavior of distributed parameter systems is proposed. The various specific characteristics of gain and phase angle of distributed parameter systems are investigated from frequency response formulation and complex plane representation of the proposed simplified model. The complex plane investigation renders some important inequality cons...
متن کاملGrinding Temperature Measurements in MgO-PSZ Using Infrared Spectrometry
Introduction When the grinding wheel specifications are properly chosen, a SiC grinding wheel performs remarkably well for grinding partially stabilized MgO-ZrO2 ceramics (MgO-PSZ). Rather surprisingly, the highest Gratios are obtained at higher grinding rates for the SiC wheel. This, and the fact that SiC grinding wheels can be readily shaped for use in precision cylindrical form grinding, has...
متن کاملTemperature distribution in workpiece during scratching and grinding
The heat transfer problem of a moving heat source along the surface of a half space was studied analytically and numerically. For the 2D problem, the heat source was a strip moving source and for the 3D problem, the heat source was a square moving source. Analytical solutions are available only for adiabatic conditions as given by Carslaw and Jaeger [H.S. Carslaw, J.C. Jaeger, Conduction of Hea...
متن کاملA Highly Simplified Thermionic Control of Temperature.
Three recent articles (1, 2, 3) describe methods of heat control which seem unnecessarily complicated in view of the present technical development of control tubes in the radio industry. Those methods, just mentioned, use mechanical relays and have wiring schemes which, although not complicated to those acquainted with radio, are nevertheless too difficult for many people to construct. One of t...
متن کاملFundamental Study on Cross Axis Grinding Method
In this study, it is experimentally investigated that the surface generation process in the cross axis grinding method with small diameter grinding wheel. In this grinding method, workpiece surface speed and sum of both wheel working surface speed and wheel feed rate crossed each other. Therefore, it is the largest characteristic that the cross angle, which is defined as the angle between the w...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Engineering Sciences
سال: 2019
ISSN: 2414-9381,2312-2498
DOI: 10.21272/jes.2019.6(2).a1/