Simplified stress analysis of multilayered adhesively bonded structures
نویسندگان
چکیده
منابع مشابه
Design Analysis of Adhesively Bonded Structures
The existing analytical solutions for the peeling and shearing stresses in polymeric adhesively bonded structures are either too inaccurate or too complex for adoption by practicing engineers. This manuscript presents a closed-form solution that is reasonably accurate yet simple and concise enough to be adopted by practicing engineers for design analysis and exploration. Analysis of these conci...
متن کاملPlastically-deforming, Adhesively-bonded Structures: I Experimental Studies
Rate effects for adhesively-bonded joints in steel sheets failing by mode-I fracture and plastic deformation were examined. Three types of test geometries were used to provide a range of crack velocities between 0.1 mm/s and 5000 mm/s: a DCB geometry under displacement control, a wedge geometry under displacement control, and a wedge geometry loaded under impact conditions. Two fracture modes w...
متن کاملDisbond detection in adhesively bonded composite structures using vibration signatures
This paper presents a structural health monitoring technique based on analysis of the dynamic signature of the structure, which changes as damage occurs, due to alterations in structural properties such as stiffness and damping. Experiments performed on plate specimens and T-joint specimens which had various degrees of damage in the form of delaminations showed that it is possible to quantify t...
متن کاملPlastically-deforming, Adhesively-bonded Structures: Ii Numerical Studies
To enable the effective and reliable use of structural adhesive bonding in automotive applications, the cohesive properties of a joint need to be determined over a wide range of loading rates. In this paper, a strategy for determining these properties has been described and used to analyze a set of experimental results presented in a companion paper. In the particular system studied, a crack gr...
متن کاملStatic analysis of adhesively bonded anchorages for CFRP tendons
In pre-stressed concrete structures, consideration is being given to replacing the steel tendons with CFRP rods. One of the challenges associated with this is to develop a suitable anchorage for the CFRP rods. A bonded anchorage was investigated, where the CFRP is potted in a steel tube using epoxy adhesive. Experimental static tests of different configurations were undertaken with failure occu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Adhesion and Adhesives
سال: 2020
ISSN: 0143-7496
DOI: 10.1016/j.ijadhadh.2019.102497