Simulation Analysis of Cracking Process of Asphalt Concrete Beam Specimen Based on Cohesive Zone Model and Extended Finite Element

fabrication of new ion sensitive field effect transistors (isfet) based on modification of junction-fet for analysis of hydronium, potassium and hydrazinium ions

a novel and ultra low cost isfet electrode and measurement system was designed for isfet application and detection of hydronium, hydrazinium and potassium ions. also, a measuring setup containing appropriate circuits, suitable analyzer (advantech board), de noise reduction elements, cooling system and pc was used for controlling the isfet electrode and various characteristic measurements. the t...

Simulation of the Mode I fracture of concrete beam with cohesive models

Crack propagation modeling in quasi-brittle materials such as concrete is essential for improving the reliability and load-bearing capacity assessment. Crack propagation explains many failure characteristics of concrete structures using the fracture mechanics approach. This approach could better explain the softening behavior of concrete structures. A great effort has been made in developing nu...

δ25 Crack opening displacement parameter in cohesive zone models: experiments and simulations in asphalt concrete

Separation Force Analysis based on Cohesive Delamination Model for Bottom-up Stereolithography Using Finite Element Analysis

Bottom-up (constrain-surface) Additive Manufacturing (AM) systems have been widely used in industry. Compared to traditional open-surface AM technology, properties like better vertical resolution, higher material filling rate, less production time, and less material waste make bottom-up AM technology a suitable candidate for fabrication of complex three dimensional materials with high accuracy....

Analysis of Roll Wear in Reshaping Using Finite Element Simulation

Reshaping process is a widely used method for producing tubes with non-circular cross sections. Owing to the friction between pipe and rolls, initial round pipe moves forward and consequently, it gradually formed into square or rectangular one. In practice, geometric profile of the rolls will be changed after a while. These changes would be detrimental the production of faultless products. Ther...