Simulation and experimental study of Pin-Plate DC discharge plasma technique
نویسندگان
چکیده
منابع مشابه
Simulation of Dust Particles Influence on Plasma of Dc Discharge
Micron size dust particles influence on nonlocal properties of complex gas discharge plasma are simulated. Plasma is described within limits of diffusion approximation, combined with OML approximation for dust component. The current-voltage characteristics as the easy-to-observe measure of dust influence on the total amount of charged particles, as well as the radial distributions of plasma com...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Experimental Study on Ozone Generation Using Dc Driven Micro- Plasma
A new type of ozone generator using a micro hollow cathode discharge has been developed. The electrode system consists of two thin metal cathodes and a ceramic spacer with center holes of a few100 mm diameter. The ozone generation efficiency increases up to 45 g/kWh at the ozone concentration of 7.6 g/Nm without any cooling systems by feeding highpressure oxygen. In this ozone generating system...
متن کاملExperimental and Numerical Study of Perforated Steel Plate Shear Panels
Thin perforated Steel Plate Shear (SPS) Walls are among the most common types of energy dissipating systems. The applied holes reduce the shear strength of the plate and allow to decrease the profile size of the members at the boundary of the panel when these systems are used in the typical design of structures. On the other hand, the different fracture locations of these panels are visible whe...
متن کاملExperimental Investigation of the Pulse and Plasma Flushing Efficiency in Electrical Discharge Machining
This paper presents a study of the relationship between Electrical Discharge Machining (EDM) parameters on the EDM efficiency factors using a full factorial design, based on pulse on-time, duty cycle and tool polarity parameters in EDM machining of AISI H13 tool steel. The results show that, in positive polarity, the plasma flushing efficiency and pulse efficiency increase according to the puls...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Iraqi Journal of Physics (IJP)
سال: 2019
ISSN: 2664-5548,2070-4003
DOI: 10.30723/ijp.v15i34.129