Simulation of Snaking and Buckling in Hot Sheet Rolling
نویسندگان
چکیده
منابع مشابه
Simulation System of Multistage Hot Rolling Process of Flat Products
The properties of each deformed product are decisively influenced by production process. By means of directed control of the various steps of process it is possible to obtain the desired properties. In order to reach this purpose and to estimate the properties of the end product the whole process chain must be presented as the whole set. This integrated approach starts with the solidified melt ...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Analyses of Buckling and Stable Tearing in Thin-Sheet Materials
This paper was to verify the STAGS (general shell, geometric and material nonlinear) code and the critical crack-tip-opening angle (CTOA) fracture criterion for predicting stable tearing in cracked panels that fail with severe out-of-plane buckling. Materials considered ranged from brittle to ductile behavior. Test data used in this study are reported elsewhere. The STAGS code was used to model...
متن کاملAn Upper Bound Analysis of Sandwich Sheet Rolling Process
In this research, flat rolling process of bonded sandwich sheets is investigated by the method of upper bound. A kinematically admissible velocity field is developed for a single layer sheet and is extended into the rolling of the symmetrical sandwich sheets. The internal, shear and frictional power terms are derived and they are used in the upper bound model. Through the analysis, the rolling ...
متن کاملAsymptotic analysis of asymmetric thin sheet rolling
An analytical model for asymmetric rolling is presented, which includes asymmetry in roll friction, roll size and roll speed, for a rigid, perfectly plastic thin sheet deformed with Coulomb friction. This model is solved asymptotically, based on the systematic assumptions that both the roll gap aspect ratio and the friction coefficient are small. While the leading order solution is shown to be ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 2018
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane.tetsu-2018-023