Simulation Of The Material Softening During Hot Metal Forming
نویسندگان
چکیده
منابع مشابه
Investigation of hot metal gas forming process of square parts
Aluminum alloys are considered a lot in the automotive and aerospace industry because of their high strength to weight ratio. In this manuscript, the gas forming process of aluminum AA6063 tubes at high temperatures up to 500°C is investigated, through experimental and numerical tests. Therefore, an experimental setup is prepared and so, tube specimens are formed in a die with square cross sect...
متن کاملThe Strain Dependence of Post-Deformation Softening during the Hot Deformation of 304H Stainless Steel
Experiments were carried out in which the dependence of the fractional softening on temperature, time and strain rate was determined in a 304H stainless steel. Three prestrain ranges were identified pertaining to three different post-deformation softening behaviors: 1) prestraining to below the DRX critical strain: strongly strain dependent softening by SRX alone with softening kinetics control...
متن کاملMetal Forming Modelling Materials Properties Critical to Simulation of Hot Stamping
Reliable simulation of hot stamping process requires accurate material data. This paper describes the development of computer models that can provide many of the material data required, including TTT/CCT phase transformation diagrams, temperature dependent physical and thermophysical properties, as well as temperature and strain rate dependent mechanical properties including high temperature st...
متن کاملInvestigation of fluid flow and heat transfer in tube hot metal gas forming process
In this study, hot metal gas forming process of AA6063aluminumtubeis studied with a focus on heat transfer of both fluid and solid phases numerically. An experimental study is simultaneously conducted to validate the numerical method. Some of the most important outputs of the present study, are velocity distribution of fluid inside the tube as well as the fluid in the gap between tube and matri...
متن کاملthe strain dependence of post-deformation softening during the hot deformation of 304h stainless steel
experiments were carried out in which the dependence of the fractional softening on temperature, time and strain rate was determined in a 304h stainless steel. three prestrain ranges were identified pertaining to three different post-deformation softening behaviors: 1) prestraining to below the drx critical strain: strongly strain dependent softening by srx alone with softening kinetics control...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Archives of Metallurgy and Materials
سال: 2015
ISSN: 2300-1909
DOI: 10.1515/amm-2015-0322