Simultaneous treatment with oil heat and densification on physical properties of Populus × Canadensis wood

نویسندگان

چکیده

Samples of wood from Populus × canadensis (9,5 % moisture) were treated with olive oil at 195 °C simultaneously 15 or 30 compression densification, and the results compared samples subjected to heat treatment without control samples. The density increased by 18 %, 43 1,5 respectively, barely changed over six subsequent months stored inside laboratory room (at approximately 65 RH, 20 °C). This was due fact that slight weight increment caused additional moisture content offset increase in volume springback effect. When atmospheres different relative humidities, stabilised same time as samples, although had a significantly lower absorption than It also observed hygroscopic shrinkage densification half those initial partially lost result springback: 3 first humidity an 4 second 85 RH. Once this latter been attained, no new losses observed. ageing used loss densest

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Densification of Wood Veneers Combined with Oil- Heat Treatment. Part Ii: Hygroscopicity and Mechanical Properties

In an effort to achieve high mechanical performance and improved dimensional stability, densification combined with oil-heat treatment (OHT) was performed. In our previous study, OHT was successfully applied to densified veneer, which resulted in improved dimensional stability. In the present study, the impact of OHT on densified wood veneer hygroscopicity and mechanical properties was determin...

متن کامل

Densification of Wood Veneers Combined with Oil- Heat Treatment. Part I: Dimensional Stability

Although wood densification by compression improves wood mechanical strength, dimensional stability is often a problem due to compression recovery. Alternatively, oil-heat treatment (OHT) improves wood dimensional stability and enhances resistance to biological attack. This study examined combined wood densification and OHT. Large wood veneer 700 × 700 mm specimens prepared with aspen (Populus ...

متن کامل

determination of some physical and mechanical properties red bean

چکیده: در این تحقیق، برخی خواص فیزیکی و مکانیکی لوبیا قرمز به-صورت تابعی از محتوی رطوبت بررسی شد. نتایج نشان داد که رطوبت بر خواص فیزیکی لوبیا قرمز شامل طول، عرض، ضخامت، قطر متوسط هندسی، قطر متوسط حسابی، سطح تصویر شده، حجم، چگالی توده، تخلخل، وزن هزار دانه و زاویه ی استقرار استاتیکی در سطح احتمال 1 درصد اثر معنی داری دارد. به طوری که با افزایش رطوبت از 54/7 به 12 درصد بر پایه خشک طول، عرض، ضخام...

15 صفحه اول

influence of temperature and holding time in oil heat treatment on physical and mechanical properties of fir wood (abies sp.)

influences of temperature as well as holding time on physical and mechanical properties of fir wood were studied in this work during the oleothermal wood modification. wood samples were cut and treated oleothermally in the soybean oil at 200 and 230°c for the holding time of 1, 3 and 5 hours. weights and the dimensions were measured before and after treatment. bending strengths, water absorptio...

متن کامل

Decay Resistance and Physical Properties of Oil Heat Treated Aspen Wood

The decay resistance of oil-heat treated aspen wood (Populus tremula l.) against white rot fungi (Coriolus versicolor) and brown rot fungi (Coniophora puteana) was investigated. Three different temperature stages and two time levels for oil heat treatment for the selection of optimum conditions were determined. Linseed oil as a heating medium was used. The mass loss of treated samples that were...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Maderas-ciencia Y Tecnologia

سال: 2021

ISSN: ['0717-3644', '0718-221X']

DOI: https://doi.org/10.4067/s0718-221x2022000100405