Single-Stage Half-Bridge Electronic Ballast Using a Single Coupled Inductor
نویسندگان
چکیده
منابع مشابه
Study and Implementation of the Passive Snubber with Coupled-Inductor in a Single-Stage Full-bridge Boost PFC
In this paper, an improved passive snubber is investigated in a single-phase single-stage full-bridge boost power factor correction (PFC) converter, by which the voltage spike across primary side of the power transformer can be suppressed and the absorbed energy can be transferred to the output side. Compared with the basic passive snubber proposed earlier, the two single-inductors are replaced...
متن کاملAn ANN Based Speed Control of PMBLDCM Drive Using a Single-Stage PFC Half-Bridge Converter
In this paper, a buck half-bridge DC-DC converter is used as a single-stage power factor correction (PFC) converter for feeding a voltage source inverter (VSI) based permanent magnet brushless DC motor (PMBLDCM) drive. The front end of this PFC converter is a diode bridge rectifier (DBR) fed from single-phase AC mains. The PMBLDCM is used to drive a compressor load of an air conditioner through...
متن کاملSingle Stage Ballast for Hps Lamps
In this paper will be reported the study and implementation of a single stage High Power Factor (HPF) electronic ballast for High Pressure Sodium (HPS) lamps using a LCC filter. In the recent years many authors are working to obtain single stage HPF electronic ballast for fluorescent lamps [1][2]. Normally to obtain HPF in electronic ballast for high pressure sodium lamps a Power Factor Preregu...
متن کاملHigh-power-factor electronic ballast based on a single power processing stage
J.L. Freitas Vieira, Mhrcio A. CO and Lucian0 D. Zorzal Universidade Federal do Espirito Santo Departamento de Engenharia Eldtrica LEPAC PO Box: 0 1-90 1 1 Vit6ria ES Brazil 29060-970 Fax: 55.27.335.2650 ABSTRACT A new low cost high power factor electronic ballast is introduced in this paper. The proposed topology is based on a single power processing stage to provide high frequency voltage to ...
متن کاملA novel single-stage push-pull electronic ballast with high input power factor
A novel single-stage push–pull electronic ballast with high input power factor is presented in this paper. The proposed electronic ballast combines the front-end power-factor corrector and push–pull converter into a single-stage converter. Compared to the single-stage class-D electronic ballast, the proposed circuit does not require an isolated driver. The control of the circuit is easier and t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Power Electronics
سال: 2012
ISSN: 1598-2092
DOI: 10.6113/jpe.2012.12.5.699