Single Stage RF Amplifier with High Gain for 2.4GHz Receiver Front-Ends
نویسندگان
چکیده
منابع مشابه
Single Stage RF Amplifier with High Gain for 2.4GHz Receiver Front-Ends
The paper deals with the numerical and experimental development of single stage radio frequency (RF) amplifier with high gain for 2.4GHz receiver front-ends. The work is motivated by the increasing demand of high-gain receiver amplifier in low-cost especially for wireless local area network (WLAN) application. Prior hardware realization and experimental characterization, the proposed amplifier ...
متن کاملMEMS Technologies and Devices for Single-Chip RF Front-Ends
Micromechanical (or “μmechanical”) components for communication applications fabricated via IC-compatible MEMS technologies and capable of low-loss filtering, mixing, switching, and frequency generation, are described with the intent to not only miniaturize and lower the parts counts of wireless front-ends via higher levels of integration, but also to eventually raise robustness (against interf...
متن کاملTuned Optical Receiver Front Ends
Unified analytical expressions have been derived for calculating the resonant frequencies, transimpedances and equivalent input noise current densities of the four most widely used tuned optical receiver front ends built with FET’s and p-i-n diodes. A more accurate FET model has been used to improve the accuracy of the analysis. The Miller’s capacitance has been taken into account, and its impa...
متن کامل24GHz CMOS direct downconversion receiver front-end and VCO design
The explosive growth of today's wireless communication market has brought an in creasing demand for high performance radio-frequency (RF) circuits in low-cost tech nologies. Because of advancements in RF CMOS circuits, devices, and passive elements in the last decade, it has become possible to develop a RF system-on-chip (SoC) that integrates RF, analog and digital circuits completely. Direct...
متن کاملA Low Noise Amplifier Optimized for a GPS Receiver RF Front End
A cascode LNA was optimized for a GPS receiver radio frequency front end using a 0.18 μm CMOS technology. By careful choice of device geometry, gate and source degeneration inductors, a fully integrated LNA can be optimized to have a low noise figure, a high voltage gain and a wide dynamic range. The optimized LNA has a 1.512 dB noise figure, a –42.05 dB S11, a 20.04 dB voltage gain a –19.82 dB...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TELKOMNIKA (Telecommunication Computing Electronics and Control)
سال: 2014
ISSN: 2302-9293,1693-6930
DOI: 10.12928/telkomnika.v12i3.100