Single transverse mode protein laser
نویسندگان
چکیده
منابع مشابه
Single-transverse-mode Ti:sapphire rib waveguide laser.
Laser operation of Ti:sapphire rib waveguides fabricated using photolithography and ion beam etching in pulsed laser deposited layers is reported. Polarized laser emission was observed at 792.5 nm with an absorbed pump power threshold of 265 mW, which is more than a factor of 2 lower in comparison to their planar counterparts. Measured beam propagation factors M2x and M2y of 1.3 and 1.2, respec...
متن کاملSingle transverse-mode laser operation of Ti:sapphire rib waveguides
Ti:sapphire is an attractive laser medium for the development of miniature lasers with widely tunable output (650-1100 nm). However, due to its low peak emission cross section and short fluorescence lifetime, high pump power densities are required to achieve efficient CW lasing. A route to address this problem is to adopt channel waveguide geometries, which are characterized by lower laser thre...
متن کاملHigh-energy single-transverse-mode Q-switched fiber laser based on a multimode large-mode-area erbium-doped fiber.
We demonstrate that appropriately designed doped multimode fibers provide robust single-mode output when used within a fiber laser cavity. Using a novel large-mode-area fiber, we demonstrate what we believe to be record single-mode (M(2) <1.2) pulse energies of >0.5 mJ from a Q -switched fiber laser and even higher pulse energies (as high as 0.85 mJ) with slightly compromised spatial-mode quali...
متن کاملModel of a two–transverse mode laser with injected signal
We derive a simple model for a two transverse mode laser (that considers the TEM00 and TEM10 modes) in which an injected signal with the shape of the TEM10 mode but a frequency close to that of the TEM00 mode is injected. Here we derive a model for a two–transverse mode laser with injected signal. More specifically, we do consider an incoherently pumped homogeneously broadened laser, in a ring ...
متن کاملDiscontinuous phase elements for transverse mode selection in laser resonators
Discontinuous phase elements can be inserted into laser resonators so that the lasers will operate with only one desired high order transverse mode. These elements introduce sharp discontinuous phase changes so as to result in minimal losses for a desired transverse mode but high losses to others. The basic principles, along with experimental results with Nd:yttrium–aluminum–garnet and CO2 lase...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Physics Letters
سال: 2017
ISSN: 0003-6951,1077-3118
DOI: 10.1063/1.5007243