Sintering dilatometry based grain growth assessment
نویسندگان
چکیده
منابع مشابه
Yttria-Ceria Stabilized Polycrystals: Sintering, Boundary Segregation Tetragonal Zirconia Grain Growth and Grain
,]u amlll'slS tS prt 'seulud o / gralu ,t~lO111/i tllld th'll,~l~COtl/m o/ r t t r la-cr l lo ,~_taluh:t'd tetlagOlla/ .llT'Ollltl Imlrcrrstal,~ ' ( ] ' , ( ' e ' I 'ZPs) u,~'lllg both i,~'/~thrrllla[ alld IlOll-I,~'otllerllla/ Icl']llllqllr,~ T/lu ch/Ir tl¢'lt'rlSlll'S O/ )', Ct' 'I~ZP.~ ' or'(' i'olup, lred 11/ thosr o/ )'. F Z f ' uud C~'. T'Z[' aud the 1'/-/('('t o/lul'r/'a,~lu,t~ i'~'l'lU ...
متن کاملTwo-step flash sintering of ZnO: Fast densification with suppressed grain growth
Article history: Received 19 June 2017 Received in revised form 14 July 2017 Accepted 14 July 2017 Available online xxxx Two-step flash sintering (TSFS) was proposed as a new ceramic fabrication method to achieve fast densification with suppressed grain growth. Using ZnO as an examplar, ~96.5% of theoretical density was achieved using TSFS with a grain size of ~370 nm, representing a N3 times r...
متن کاملDynamic aspects of cerium dioxide sintering: HT-ESEM study of grain growth and pore elimination
Graphical abstract summary: Sintering of CeO 2 is studied by in situ high temperature scanning environmental microscopy (HT-ESEM) at T=1400°C. The morphological modifications of a single grains population are recorded for 6 hours. Kinetic parameters such as grain boundary velocities are extracted from the obtained image series. An intragranular surface pore elimination process is observed. ABST...
متن کاملSintering boron carbide ceramics without grain growth by plastic deformation as the dominant densification mechanism
A new ceramic sintering approach employing plastic deformation as the dominant mechanism is proposed, at low temperature close to the onset point of grain growth and under high pressure. Based on this route, fully dense boron carbide without grain growth can be prepared at 1,675-1,700 °C and under pressure of (≥) 80 MPa in 5 minutes. The dense boron carbide shows excellent mechanical properties...
متن کاملSintering and yttrium grain boundary segregation in sub-micron grain size alumina
Sintering behavior with and without external stress was investigated using undoped and doped (1500 ppm yttria) sub-micron a-alumina powders. The yttria doped alumina showed anomalous behavior with grain size around 0.9 pm, a second peak in densification rate during free sintering and a stagnation followed by a steep increase in flow stress during sinter forging. These were thought to correspond...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Results in Physics
سال: 2018
ISSN: 2211-3797
DOI: 10.1016/j.rinp.2018.05.014