SIZE CLASSIFICATION WITH 3D IMAGING USE FOR WOODCHIPS
نویسندگان
چکیده
منابع مشابه
Validation of Optimum ROI Size for 123I-FP-CIT SPECT Imaging Using a 3D Mathematical Cylinder Phantom
Objective(s): The partial volume effect (PVE) of single-photon emission computed tomography (SPECT) on corpus striatum imaging is caused by the underestimation of specific binding ratio (SBR). A large ROI (region of interest) set using the Southampton method is independent of PVE for SBR. The present study aimed to determine the optimal ROI size with contrast and SBR for striatum images and val...
متن کاملOn the Use of Variable-Size Fuzzy Clustering for Classification
Hard c-means can be used for building classifiers in supervised machine learning. For example, in a n-class problem, c clusters are built for each of the classes. This results into n · c centroids. Then, new examples can be classified according to the nearest centroid. In this work we consider the problem of building classifiers using fuzzy clustering techniques. In particular, we consider the ...
متن کاملPotential Cost Savings for Use of 3D Printing Combined With 3D Imaging and CPLM for Fleet Maintenance and Revitalization
Same as Report (SAR) 18. NUMBER
متن کاملAdaptive beamforming in row-column addressed arrays for 3D ultrasound imaging
In recent years, to reduce the complexity of implementation, the use of 2D arrays with restricted row-column addressing has been considered for 3D ultrasound imaging. In this paper, two methods of adaptive beamforming based on the minimum variance method are represented in such a way that the computational load is much less than using the full adaptive beamforming method. In both proposed metho...
متن کاملFabrication of New 3D Phantom for Measuring Geometric Distortion in Magnetic Resonance Imaging System
Introduction: Geometric distortion is a major shortcoming of magnetic resonance imaging (MRI), which has an important influence on the accuracy of volumetric measurements, an important parameter in neurology and oncology. Our goal is to design and construct a new three- dimensional phantom using a 3D printer in order to measure geometric distortion and its reproducibility in...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ANNALS OF THE ORADEA UNIVERSITY. Fascicle of Management and Technological Engineering.
سال: 2012
ISSN: 1583-0691
DOI: 10.15660/auofmte.2012-1.2733