Slip Length Measurement of Confined Air Flow on Three Smooth Surfaces

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Slip-length measurement of confined air flow using dynamic atomic force microscopy.

We present an experimental measurement of the slip length of air flow close to solid surfaces using an atomic force microscope (AFM) in dynamic mode. The air was confined between a glass surface and a spherical glass particle glued to an AFM cantilever. The Knudsen number was varied continuously over three decades by varying the distance between the two surfaces. Our results show that the effec...

متن کامل

Measurement of slip length on superhydrophobic surfaces.

In this paper, a review of different techniques used to measure the slip length on superhydrophobic surfaces with large slip length is presented. First, we present the theoretical models used to calculate the effective slip length on superhydrophobic surfaces in different configurations of liquid flow. Then, we present the different techniques used to measure the slip past these superhydrophobi...

متن کامل

Simulations of slip flow on nanobubble-laden surfaces.

On microstructured hydrophobic surfaces, geometrical patterns may lead to the appearance of a superhydrophobic state, where gas bubbles at the surface can have a strong impact on the fluid flow along such surfaces. In particular, they can strongly influence a detected slip at the surface. We present two-phase lattice Boltzmann simulations of a flow over structured surfaces with attached gas bub...

متن کامل

Measurement of no-slip and slip boundary conditions in confined Newtonian fluids using atomic force microscopy.

We report measurements of slip length at smooth and rough hydrophilic silica surfaces, using the hydrodynamic force measurement atomic force microscope (AFM). There has been some debate in the literature as to whether the boundary condition between a solid and a wetting fluid is one of no-slip or partial-slip; in particular the results of Neto et al. (C. Neto, V. S. J. Craig and D. R. M. Willia...

متن کامل

Rate-dependent slip of Newtonian liquid at smooth surfaces.

Newtonian fluids were placed between molecularly smooth surfaces whose spacing was vibrated at spacings where the fluid responded as a continuum. Hydrodynamic forces agreed with predictions from the no-slip boundary condition only provided that flow rate (peak velocity normalized by spacing) was low, but implied partial slip when it exceeded a critical level, different in different systems, cor...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Langmuir

سال: 2013

ISSN: 0743-7463,1520-5827

DOI: 10.1021/la400199k