Solidification and Solidification Structure Control of Weld Metals.
نویسندگان
چکیده
منابع مشابه
Model Based Control of Solidification
In this paper, model based control of solidification is studied. A one-dimensional model that describes the dynamic response of the solidification rate for a pure substance is developed. The solidification of a metal column is controlled in order to solidify at a desired rate. The manipulated variable is the power to the heater at the top of the casting. A linear PI-controller is implemented an...
متن کاملNanoparticle-induced unusual melting and solidification behaviours of metals
Effective control of melting and solidification behaviours of materials is significant for numerous applications. It has been a long-standing challenge to increase the melted zone (MZ) depth while shrinking the heat-affected zone (HAZ) size during local melting and solidification of materials. In this paper, nanoparticle-induced unusual melting and solidification behaviours of metals are report...
متن کاملSolidification/stabilization of toxic metals in calcium aluminate cement matrices.
The ability of calcium aluminate cement (CAC) to encapsulate toxic metals (Pb, Zn and Cu) was assessed under two curing conditions. Changes in the consistency and in the setting time were found upon the addition of the nitrates of the target metals. Both Pb and Cu caused a delay in CAC hydration, while Zn accelerated the stiffening of the mortar. Compressive strengths of the metal-doped mortars...
متن کاملFeedback control of unstable cellular solidification fronts.
We present a feedback control scheme to stabilize unstable cellular patterns during the directional solidification of a binary alloy. The scheme is based on local heating of cell tips which protrude ahead of the mean position of all tips in the array. The feasibility of this scheme is demonstrated using phase-field simulations and, experimentally, using a real-time image processing algorithm, t...
متن کامل' * , sy Solidification Behavior and Structure of AI - Cu Alloy Welds
The microsegregation behavior of electron beam (EB, and gas tungsten arc (GTA) welds of Al-Cu alloys covering a range from 0.19 to 7.74 wt% Cu were characterized for dendrite core concentrations and fraction eutectic solidification. Although a single weld speed of 12.7 mm/sec was used, some differences were observed in the segregation behavior of the two weld types. The microsegregation behavio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Welding Society
سال: 2001
ISSN: 0021-4787,1883-7204
DOI: 10.2207/qjjws1943.70.5_579