Spattering in pulsed GMA welding.
نویسندگان
چکیده
منابع مشابه
Control of pulsed gas metal arc welding
This paper presents a control system for manual pulsed Gas Metal Arc Welding (GMAW). This system consists of a current controller, which makes it possible to shape the current during welding, and two important components, which are the key issues discussed in this paper. These components include an arc length controller and a metal transfer controller. The arc length controller is based on a no...
متن کاملNumerical and experimental study of thermally induced residual stress in the hybrid laser–GMA welding process
Amodel based on a double-ellipsoidal volumeheat source to simulate the gasmetal arcwelding (GMAW) heat input and a cylindrical volume heat source to simulate the laser beam heat input was developed to predict the temperature field and thermally induced residual stress in the hybrid laser–gas metal arc (GMA) welding process. Numerical simulation shows that higher residual stress is distributed i...
متن کاملApplication of YAG Pulsed Laser Micro-Welding in MEMS Packaging
This paper reports a new packaging method for a wide range of MEMS for application on both the wafer and device scale. Titanium is used as the packaging material in this work and both silicon and titanium MEMS devices are integrated on to a titanium substrate. A Nd:YAG pulsed laser is used to micro-weld the titanium cap to the substrate. A three-dimensional time dependent model of heat flow dur...
متن کاملPorosity Formation and Prevention in Pulsed Laser Welding
Porosity has been frequently observed in solidified, deep penetration pulsed laser welds. Porosity is detrimental to weld quality. Our previous study shows that porosity formation in laser welding is associated with the weld pool dynamics, keyhole collapse, and solidification processes. The objective of this paper is to use mathematical models to systematically investigate the transport phenome...
متن کاملA Non-Intrusive GMA Welding Process Quality Monitoring System Using Acoustic Sensing
Most of the inspection methods used for detection and localization of welding disturbances are based on the evaluation of some direct measurements of welding parameters. This direct measurement requires an insertion of sensors during the welding process which could somehow alter the behavior of the metallic transference. An inspection method that evaluates the GMA welding process evolution usin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY
سال: 1986
ISSN: 0288-4771
DOI: 10.2207/qjjws.4.684