Special issue "Vibration isolation, vibration control and sound isolation". II. Development of adaptive tuned mass damper using air spring.
نویسندگان
چکیده
منابع مشابه
Fully Adaptive Semi-active Control of Vibration Isolation by Mr Damper
This paper is concerned with a new fully adaptive control scheme for vibration isolation using a semi-active MR damper installed between ground and first floor, which is composed of two adaptive controllers. One is an adaptive inverse controller which can give necessary input voltage to MR damper so as to generate specified reference damping force to be acted on a controlled structure. The inpu...
متن کاملAdaptive control of a two-stage vibration isolation mount
An adaptive control system has been developed that may be used for active noise and vibration control problems involving one-dimensional propagation. Based on the least-mean-squares (LMS) algorithm, the adaptive controller performs both system identification and control in real time, without the need for a priori measurements of the system. Since the controller is adaptive in nature, it is poss...
متن کاملSingle Network Adaptive Critic for Vibration Isolation Control ?
Vibration isolation control is the critical issue to guarantee the performance of various vibration-sensitive instruments and sensors in practical engineering systems. In this paper, single network adaptive critic (SNAC) based controllers are developed for vibration isolation applications. The SNAC approach differs from the typical action-critic dual network structure in adaptive critic designs...
متن کاملAdaptive Control for a Microgravity Vibration Isolation System
Most active vibration isolation systems that try to a provide quiescent acceleration environment for space-science experiments have utilized linear design methods. In this paper, we address adaptive control augmentation of an existing classical controller that combines a high-gain acceleration inner-loop feedback together with a low-gain position outer-loop feedback to regulate the platform abo...
متن کاملDesign of a non-contact magnetic spring for vibration isolation
This document serves to summarise the research performed by the author undertaken in approximately the first six months of his doctorate. The aim of the project is to build a vibration isolation table using non-contact magnetic springs. The document is structured with an introduction to the project, followed by an introduction to the field of magnetic levitation, including a literature review. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: NIPPON GOMU KYOKAISHI
سال: 1991
ISSN: 1884-0442,0029-022X
DOI: 10.2324/gomu.64.308