Squeeze casting of potassium titanate whisker reinforced aluminum composites.
نویسندگان
چکیده
منابع مشابه
Casting of SiC Reinforced Metal Matrix Composites
Composites based on two aluminium alloys (A536 and 6061) reinforced with 10% or 20% volume fraction of SiC particles were produced by gravity casting and a novel two-step mixing method was applied successfully to improve the wettability and distribution of the particles. The SiC particles were observed to be located predominantly in the interdendrit ic regions, and a thermal lag model is propos...
متن کاملFatigue crack growth resistance in SiC particulate and whisker reinforced P/M 2124 aluminum matrix composites
Fatigue crack growth is examined in P/M 2124 aluminum alloys reinforced with SiC particles (SiCp) and whiskers (SiCw) over a wide spectrum of growth rates from 10 to 10 m per cycle. Effects of aging treatment, orientation of crack growth direction with respect to the rolling direction, mean stress (or stress ratio), and reinforcement volume percent on the fatigue crack growth threshold are inve...
متن کاملProcessing and Characterization of AA2024/Al2O3/SiC Reinforces Hybrid Composites Using Squeeze Casting Technique
The present requirement of automobile industry is seeking lightweight material that satisfices the technical and technological requirements with better mechanical and tribological characteristics. Aluminium matrix composite ( AMC ) materials meet the requirements of the modern demands. AMCs are used in automotive applications as engine cylinders, pistons, disc and drum brakes. This paper inves...
متن کاملFabrication of in situ TiC reinforced aluminum matrix composites
In the present work, the room and elevated temperature mechanical behavior of Al/TiC, high-strength Al-Si/TiC and the elevated temperature-resistant Al-Fe(-V-Si)/TiC composites has been evaluated. The microstructural characteristics of ingot metallurgy (IM) or rapid solidification (RS) Al-Si/TiC and Al-Fe(-V-Si)/TiC composites could be thought of as a combination of the related alloy matrix mic...
متن کاملStudy on Machining Parameters of TiB2 Reinforced Aluminum 6063 Composites
In this experimental study, three TiB2/Al metal matrix composites (MMCs) with 40 μm in mean size were produced using a melt stirring squeeze casting route. Test was carried out to find the parameters influencing surface roughness (Ra) and material removal rate (MRR) on machining the TiB2 reinforced Al-6063 composite materials. The orthogonal array, the signal-to-noise ratio, and analysis of var...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1990
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.37.984