Stack Design Parameters Influencing Plume Rise
نویسندگان
چکیده
منابع مشابه
Using infrasound to constrain ash plume rise
Airborne volcanic ash advisories are currently based on analyses of satellite imagery with relatively low temporal resolution, and numerical simulations of atmospheric plume dispersion. These simulations rely on key input parameters such as the maximum height of eruption plumes and the mass eruption rate at the vent, which remain loosely constrained. In this study, we present a proof-of-concept...
متن کاملnumerical simulation of plume rise in neutral atmospheric stability condition
introduction air pollution has harmful effect on human health and the environment. accordingly, considerable effort has been put to analyze the air pollutants. one important issue is the spatial distribution of these pollutants. dispersion of the pollutants released from sources on the ground is mostly driven by the planetary boundary layer where turbulent flow causes mixing of the content of t...
متن کاملHot Towers Formation – a Simple Plume Rise Model
Hurricane intensification has been studied by scientists for decades and one phenomenon that appears to always accompany the intensification is the presence of hot towers of cumulous clouds that stretches to 15 km high, touching the top of the troposphere (Figure 1a &b). The hypothesis of Hot towers was first proposed in 1958 by Riehl and Malkus (Anthes, 1999), who wrote in conclusion from thei...
متن کاملPlume Rise from GigaWatt Fires: Observations and Models
Data are presented from 15 prescribed fires of forest slash in the Pacific Northwest. Total energies varied between 3 and 35 TeraJoules (TJ}, maximum flame powers, P, between 0.4 and 6.9 GigaWatts (GW), and highest observed plume-top altitudes, Zo, between 700 and 3000 meters above the burn sites. For these fires a two-parameter empirical model gave Zm ≈ 1403 P0.36 meters, with rms errors of 39...
متن کاملSensitivity of air quality simulation to smoke plume rise
Plume rise is the height smoke plumes can reach. This information is needed by air quality models such as the Community Multiscale Air Quality (CMAQ) model to simulate physical and chemical processes of point-source fire emissions. This study seeks to understand the importance of plume rise to CMAQ air quality simulation of prescribed burning to plume rise. CMAQ simulations are compared between...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Air Pollution Control Association
سال: 1968
ISSN: 0002-2470
DOI: 10.1080/00022470.1968.10469155