State estimation: A comparison between direct state measurement and tomography
نویسندگان
چکیده
منابع مشابه
Quantum State Tomography via Linear Regression Estimation
A simple yet efficient state reconstruction algorithm of linear regression estimation (LRE) is presented for quantum state tomography. In this method, quantum state reconstruction is converted into a parameter estimation problem of a linear regression model and the least-squares method is employed to estimate the unknown parameters. An asymptotic mean squared error (MSE) upper bound for all pos...
متن کاملMulti-frame Measurement Fusion for State Estimation
David Kroetsch Master of Applied Science University of Waterloo September 2007 Multi-frame Measurement Fusion for State Estimation Simultaneous Localization and Mapping (SLAM) is a technique used by robots and autonomous vehicles to build up a map while operating in an unknown environment, while at the same time keeping track of a current position estimate. This process is not as straightforwar...
متن کاملMulti-objective Measurement Devices Allocation Using State Estimation in Distribution System
Allocation of measurement devices is a necessity of distribution system which is an application of state estimation. In this paper, the problem of active and reactive measurement devices is modeling using a multi-objective method. The objectives of the problem are to minimize the use of measurement devices, increase in state estimation output, improve the state estimation quality and reduce cos...
متن کاملRobust state estimation in power systems using pre-filtering measurement data
State estimation is the foundation of any control and decision making in power networks. The first requirement for a secure network is a precise and safe state estimator in order to make decisions based on accurate knowledge of the network status. This paper introduces a new estimator which is able to detect bad data with few calculations without need for repetitions and estimation residual cal...
متن کاملQuantum state tomography with a single measurement setup
The field of quantum information relies on the crucial issue of characterizing quantum states frommeasurements. This is performed through a process called quantum state tomography (QST). However, QST requires a large number of measurements, each derived from a different physical observable corresponding to a different experimental setup. Changing the setup results in unwanted changes to the dat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review A
سال: 2014
ISSN: 1050-2947,1094-1622
DOI: 10.1103/physreva.89.022122