Static Recrystallization Microstructure Evolution in a Cold-Deformed Ni-Based Superalloy during Electropulsing Treatment
نویسندگان
چکیده
منابع مشابه
Lattice strain evolution and load partitioning during creep of a Ni-based superalloy single crystal with rafted microstructure
In-situ neutron diffraction measurements were performed on monocrystalline samples of the Ni-based superalloy CMSX-4 during N-type g0 raft formation under the tensile creep conditions of 1150 C/ 100 MPa, and subsequently on a rafted sample under the low temperature/high stress creep conditions of 715 C/825 MPa. During 1150 C/100 MPa creep, the g0 volume fraction decreased from ~70% to ~50%, the...
متن کاملthe effect of heat treatment on the microstructure of cast ni-based in100 superalloy
the purpose of this study was to investigate the effect of heat treatment including solution treatment and aging on the microstructure of cast nickel-based in100 superalloy including size, volume fraction and morphology of primary γ' and different kinds of carbides. for this purpose, different solution heat treatment cycles and a constant aging cycle were implemented on cast ingot samples and t...
متن کاملIsothermal Recrystallization Behavior of Cold-deformed Martensite in an Ultra-low-carbon Microalloyed Steel
One of the most promising ways to produce a grain-refined microstructure in some steel materials is the thermomechanical processing route of subcritical recrystallization annealing of a cold-deformed martensite structure. In the present study, the microstructural evolutions and the associated recrystallization kinetics under various subcritical annealing heat treatment conditions are explored i...
متن کاملA synchrotron study of microstructure gradient in laser additively formed epitaxial Ni-based superalloy
Laser additive forming is considered to be one of the promising techniques to repair single crystal Ni-based superalloy parts to extend their life and reduce the cost. Preservation of the single crystalline nature and prevention of thermal mechanical failure are two of the most essential issues for the application of this technique. Here we employ synchrotron X-ray microdiffraction to evaluate ...
متن کاملDirectional Solidification Microstructure of a Ni-Based Superalloy: Influence of a Weak Transverse Magnetic Field
A Ni-based superalloy CMSX-6 was directionally solidified at various drawing speeds (5–20 μm·s−1) and diameters (4 mm, 12 mm) under a 0.5 T weak transverse magnetic field. The results show that the application of a weak transverse magnetic field significantly modified the solidification microstructure. It was found that if the drawing speed was lower than 10 μm·s−1, the magnetic field caused ex...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Crystals
سال: 2020
ISSN: 2073-4352
DOI: 10.3390/cryst10100884