Static test of a variable stiffness thermoplastic composite wingbox under shear, bending and torsion
نویسندگان
چکیده
منابع مشابه
Friction Compensation and Stiffness Evaluation on a Variable Torsion Stiffness
With safety aspects due to closer human-robot interaction and increased requirements in energy effiency due to mobile applications, series elastic joint concepts receive high priority in contemporary robotics. Beyond making robots more safe and flexbile, such concepts can store energy and thus optimize the energetic efficiency of the robot’s motion. Therefore adjusting the stiffness is advantag...
متن کاملComparison of plasticity and stiffness of steel shear walls with composite steel plate shear wall
The steel shear wall and composite steel plate shear wall is introduced in recent three decade and is considered and is spread rapidly. Composite steel plate shear wall which is made of a layer of thin steel sheet with coating of reinforced concrete in one or both sides of steel palate is considered a third generation of resistance shear walls against lateral loads that in addition to increasin...
متن کاملOptimal plastic design of a bar under combined torsion, bending and shear
Optimal plastic design of a bar or beam under torsion with superposed bending and shear is obtained via the boundary perturbation method. Effects of bending and shear are expressed by a small parameter α. The results of optimization of solid bars and of hollow bars are shown.
متن کاملFree Vibration Analysis of Variable Stiffness Composite Laminates with Flat and Folded Shapes
In this article, free vibration analysis of variable stiffness composite laminate (VSCL) plates with flat and folded shapes is studied. In order to consider the concept of variable stiffness, in each layer of these composite laminated plates, the curvilinear fibers are used instead of straight fibers. The analysis is based on a semi-analytical finite strip method which follows classical laminat...
متن کاملBehavior of Steel–Concrete Composite Beams with Corroded Shear Studs Under Negative Bending Moment
The behavior of corroded steel–concrete composite beams under hogging moment was studied by experimental investigation and theoretical analysis. A total of eight specimens, six of which had corroded shear studs, were tested. The corrosion rate of studs ranged from 0 to approximately 50%. The constant-current accelerated corrosion method was adopted to accelerate the corrosion process. The loadi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Aeronautical Journal
سال: 2020
ISSN: 0001-9240,2059-6464
DOI: 10.1017/aer.2019.161