Steady state cyclic behaviour of a half-plane contact in partial slip subject to varying normal load, moment, shear load, and moderate differential bulk tension
نویسندگان
چکیده
منابع مشابه
An integral formulation for steady-state elastoplastic contact over a coated half-plane
A boundary-domain integral equation for a coated half-space (elastically isotropic homogeneous substratum, possibly anisotropic coating layer) is developed. The half-space fundamental solution is used, so that the discretization is limited to the potential contact zone (boundary elements), the potentially plastic part of the substratum and the coating layer (domain integration cells). Steady-st...
متن کاملCapacitor Placement in Distorted Distribution Network Subject to Wind and Load Uncertainty
Utilizing capacitor banks is very conventional in distribution network in order for local compensation of reactive power. This will be more important considering uncertainties including wind generation and loads uncertainty. Harmonics and non-linear loads are other challenges in power system which complicates the capacitor placement problem. Thus, uncertainty and network harmonics have been con...
متن کاملMechanical behaviour of articular cartilage under tensile cyclic load.
INTRODUCTION Although fatigue has been implicated in cartilage failure, there are only two published studies in this area, by the same author. However, in these previous studies cartilage was tested in the direction parallel to that of collagen orientation in the superficial layer, where it possesses greater tensile strength. In the present work, articular cartilage was also tested along the di...
متن کاملContact Behaviour of Composite Laminate under Quasi-Static Indentation Load
A viable solution to the ever-demanding weight-saving target in aerospace industry is the replacement of conventional engineering alloys with composite materials in primary structures. A major concern to the effective use of composite laminates is the substantial reduction in the compressive strength when the contact force has exceeded the delamination threshold load (DTL). This paper focuses o...
متن کاملSteady Thermal Stresses in a Thin Rotating Disc of Finitesimal Deformation with Mechanical Load
Seth’s transition theory is applied to the problems of thickness variation parameter in a thin rotating disc by finite deformation. Neither the yield criterion nor the associated flow rule is assumed here. The results obtained here are applicable to compressible materials. If the additional condition of incompressibility is imposed, then the expression for stresses corresponds to those arising ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Solids and Structures
سال: 2020
ISSN: 0020-7683
DOI: 10.1016/j.ijsolstr.2019.07.027