Steel Beam Compressive Strain Sensor Using Single-Mode-Multimode-Single-Mode Fiber Structure
نویسندگان
چکیده
منابع مشابه
Fiber refractometer based on a fiber Bragg grating and single-mode-multimode-single-mode fiber structure.
A refractive index (RI) sensor based on a novel fiber structure that consists of a single-mode-multimode-single-mode (SMS) fiber structure followed by a fiber Bragg grating was demonstrated. The multimode fiber in the SMS structure excites cladding modes within output single-mode fiber (SMF) and recouple the reflected cladding Bragg wavelength to the input SMF core. By measuring the relative Br...
متن کاملNew Design of Optical Filters Based on Single Mode-Multimode-Single Mode Fiber Structure for Optical Fiber Communication Systems
In this paper, a design of optical filters based on single mode-multimode-single mode fiber structure (SMS) is demonstrated. The multimode interference effect can be utilized to design wavelength-selective devices with high extinction ratio. The proposed optical filters are realized by using standard optical fibers. Two optical filters are designed to operate with wave division multiplexing (WD...
متن کاملLaser beam shaping using a single-mode fiber abrupt taper.
A new beam-shaping device was realized by an abrupt taper with a length of approximately 700 microm and a waist of approximately 40 microm. The insertion loss of the device is less than 3%. The diameter of the flat beam top can be up to approximately 900 microm with a small intensity variation (4%) and a small half-divergence angle (2.5 degrees). The conversion efficiency of the new device from...
متن کاملSingle-mode operation of a coiled multimode fiber amplifier.
We report a new approach to obtaining single-transverse-mode operation of a multimode fiber amplifier in which the gain fiber is coiled to induce significant bend loss for all but the lowest-order mode. We demonstrated this method by constructing a coiled amplifier using Yb-doped, double-clad fiber with a core diameter of 25 microm and a numerical aperture of ~0.1 (V approximately 7.4) . When t...
متن کاملA single source microwave photonic filter using a novel single-mode fiber to multimode fiber coupling technique.
In this paper we present a fully tunable and reconfigurable single-laser multi-tap microwave photonic FIR filter that utilizes a special SM-to-MM combiner to sum the taps. The filter requires only a single laser source for all the taps and a passive component, a SM-to-MM combiner, for incoherent summing of signal. The SM-to-MM combiner does not produce optical interference during signal merging...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Photonics Journal
سال: 2016
ISSN: 1943-0655
DOI: 10.1109/jphot.2016.2523255