Strain Distribution Evaluation of Rat Tibia under Axial Compressive Load by Combining Strain Gauge Measurement and Finite Element Analysis
نویسندگان
چکیده
منابع مشابه
Analysis of Strain Inhomogeneity in Vortex Extrusion using Finite Element Method and Response Surface Methodology
The effect of geometrical parameters involved in vortex extrusion (VE) die design, on AA1050 aluminium alloy processed by VE were investigated using finite element analysis (FEA) and response surface methodology (RSM). For this, VE die length (L), reduction in area (RA), twist angle , and position of control points in Beziers' formulation (C1) were considered as input parameters and strain inho...
متن کاملDetermination of Buckling Limit of Strain in Cold Roll Forming through Finite Element Analysis
In this study, Buckling Limit of Strain (B.L.S.) is introduced as one of the most important limiting factors in cold roll forming process. B.L.S. is calculated by the finite element procedure. Then for two particular processes with existing analysis and experimental results, B.L.S. has been determined and evaluated. LUSAS 12.3 is used for finite element analysis. The results show that when buck...
متن کاملCorrecting the stress-strain curve in hot compression test using finite element analysis and Taguchi method
In the hot compression test friction has a detrimental influence on the flow stress through the process and therefore, correcting the deformation curve for real behavior is very important for both researchers and engineers. In this study, a series of compression tests were simulated using Abaqus software. In this study, it has been employed the Taguchi method to design experiments by the factor...
متن کاملDetermination of Buckling Limit of Strain in Cold Roll Forming through Finite Element Analysis
In this study, "Buckling Limit of Strain" (B.L.S.) is introduced as one of the most important limiting factors in cold roll forming process. B.L.S. is calculated by the finite element procedure. Then for two particular processes with existing analysis and experimental results, B.L.S. has been determined and evaluated. LUSAS 12.3 is used for finite element analysis. The results show that when bu...
متن کاملDetecting compressive strain by evaluation of Raman spectroscopy of the multiwall Carbon nanotubes/TiO2 nanocomposites
Functionalized Multi-walled carbon nanotubes (f-MWCNTs) which are modified using nitric acid and sulfuric acid were evaluated to synthesize a uniform nanocomposite via application of TiO2. The f-MWCNTs-TiO2 nanocomposites have been produced via using the chemical simple two-step method. To characterize the structural analysis, scanning electron microscopy...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Bionics and Biomechanics
سال: 2019
ISSN: 1176-2322,1754-2103
DOI: 10.1155/2019/1736763