Strain Ratio Relationship in Plastic Deformation
نویسندگان
چکیده
منابع مشابه
Stress-strain relations for crystals containing plastic deformation.
Let P be one of the possible slip planes in a crystal, and let X be one of the possible slip directions in the plane P. Also let S be the magnitude of the shearing stress on the plane P resolved in the direction X, and So the critical value of S, i.e., the least value of S sufficient to permit slip or plastic deformation under the conditions specified in the following italicized statement; if s...
متن کاملOn the Relationship Between Deformation-Induced Surface Roughness and Plastic Strain in AA5052—Is it Really Linear?
Three different heat treatments of aluminum alloy AA5052 were subjected to various levels of uniaxial plastic strain. The resulting surfaces were then evaluated using both scanning laser confocal microscopy (SLCM) and stylus profilometry. Three regression approaches were used to assess the quality of a linear and a curvilinear fit for the roughness data as a function of true plastic strain. Whi...
متن کاملMeasuring Plastic Deformation
This article describes the current level of understanding of dislocation plasticity in thin films and small structures in which the film or structure dimension plays an important role. Experimental observations of the deformation behavior of thin films, including mechanical testing as well as electron microscopy studies, will be discussed in light of theoretical models and dislocation simulatio...
متن کاملPlastic deformation analysis in parallel tubular channel angular pressing (PTCAP)
Parallel tubular channel angular pressing (PTCAP) process is a novel recently developed severe plastic deformation technique for fabrication of ultrafine grained (UFG) metallic tubes. This new process consists of two half cycles and is affected by several parameters such as channel angles, deformation ratio and curvature angles. In this paper, the effects of these parameters on the plastic defo...
متن کاملSevere Plastic Deformation of Metals
This paper provides an introduction in the field of severe plastic deformation (SPD). First of all the main methods to produce SPD materials are discussed. In the following section, the mechanisms leading to the formation of fine grains are reviewed and the influence of changes in strain path is highlighted. During post-SPD thermal annealing, some typical microstructural changes take place. The...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1960
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.26.1327