Strength and HRTEM microstructure at bond interface of aluminum/copper clad materials
نویسندگان
چکیده
منابع مشابه
Experimental Investigation of the Methods of Evaluating the Bond Strength Between Concrete Substrate and Repair Materials
This investigation was aimed at studying the effect of test methods on bond strength between concrete substrate and repair material. Four test methods with cementations or modified-cementations repair materials, and two surface roughnesses were studied. The methods used were pull-off, slant shear, splitting prism and a new direct shear named Bi-Surface shear test. While the coefficient of varia...
متن کاملShear Bond Strength of Acrylic Denture Teeth to PMMA and Polyamide Denture Base Materials
Introduction: Detachment of denture teeth from denture base is one of the most common reasons for costly denture repairs .This study aimed at evaluating the bond strength of an acrylic denture tooth to polyamide injection-molded thermoplastic denture base material compared with three conventional polymethylmethacrylate (PMMA) denture base resins. Materials and Method: A total of 40 acrylic dent...
متن کاملOrthodontics: Bracket Materials, Adhesives Systems, and Their Bond Strength
1Unit of Orthodontics and Paediatric Dentistry, Section of Dentistry, Department of Clinical, Surgical, Diagnostic and Paediatric Sciences, University of Pavia, Pavia, Italy 2Facultad de Odontologı́a, Universidad Autónoma del Estado de México, Toluca, MEX, Mexico 3Orthodontic Department, Faculty of Dentistry, Mansoura University, Mansoura, Egypt 4Institute of Dentistry, Faculty of Medicine, Univ...
متن کاملEffect of high-concentrated bleaching agents on the bond strength at dentin/resin interface and flexural strength of dentin.
This study evaluated the effect of bleaching agents on bond strength at the dentin/resin interface and the flexural strength of dentin. Forty maxillary canines were selected for the study. In the shear strength test, 40 slabs of intracoronary dentin (5 x 5 mm) obtained from buccal surfaces of the crowns were included in acrylic resin. In the flexural strength test, 40 dentin bars (8 x 2 x 2 mm)...
متن کاملComparison of shear bond strength of aesthetic restorative materials
AIM The present study was conducted to determine and compare the shear bond strengths of Conventional glass ionomer; Resin-modified glass ionomer; Polyacid-modified composite and Composite Resin, and to assess and determine the mode of failure (adhesive, cohesive, mixed). MATERIALS AND METHODS Occlusal dentin of 40 extracted human teeth were randomly divided into four groups of ten teeth, eac...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 2009
ISSN: 0451-5994,1880-8018
DOI: 10.2464/jilm.59.542