Stress Concentration Problems Produced by Cruciate Hole
نویسندگان
چکیده
منابع مشابه
Stress Concentration Factor in a Functionally Graded Material Plate around a Hole
Stress concentration factors have been examined in a functionally graded material (FGM) plate with central holes in different shapes in this essay. The material properties change along the thickness of plate. ABAQUS software has been utilized for modeling of problem in which subroutine of ABAQUS sub-program was used for modeling of the targeted material. The considering shapes for hole in plate...
متن کاملreducing stress concentration factor around a hole on a plate by piezoelectric patch
using piezoelectric patches the stress concentration around a hole on a plate under tension is reduced and controlled. to attain the reduction in stress two placements for piezoelectric patches is investigated. the first location is top/bottom of the hole with compression induced strain and the second is left/right of the hole with tension induced strains to control the stress flow. the result ...
متن کاملStress concentration in a circular hole in composite plate
A non-contact measurement method, namely electronic speckle pattern interferometer (ESPI), was used to investigate the tensile strain field of a composites plate in the presence of stress concentrations caused by a geometrical defect consisting of circular hole. ESPI uses the principle of 3D speckle interferometry to measure the deformation and contour of the measuring field with submicrometer ...
متن کاملThe Effect of Volume Fractions on Hole Stress Concentration in Composite Lamina Subjected to Matrix Plasticity
In this paper, the stress concentration around a hole in the single layer composite materials with long fibers is examined. The single layer has an infinite length, limited with and instant thickness and is loaded by a constant tension force p at infinity. The width of the lamina is considered to be finite and bears a hole as a defect. Due to presence of excessive shear stress in the matrix bay...
متن کاملStress Concentration Factor in a Functionally Graded Material Plate around a Hole
Stress concentration factors have been examined in a functionally graded material (FGM) plate with central holes in different shapes in this essay. The material properties change along the thickness of plate. ABAQUS software has been utilized for modeling of problem in which subroutine of ABAQUS sub-program was used for modeling of the targeted material. The considering shapes for hole in plate...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1957
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.23.124