Stress-Strain Curves of Steels
نویسندگان
چکیده
منابع مشابه
PREDICTION OF CRITICAL STRESS AND STRAIN FOR THE ONSET OF DYNAMIC RECRYSTALLIZATION IN PLAIN CARBON STEELS
The aim of the present study is the prediction of critical conditions (including critical strain and flow stress) for the initiation of dynamic recrystallization during thermo-mechanical processing of plain carbon steels. For this propose, torsion tests were conducted at different temperature (1050, 1100 and 1150˚C) and strain rates (0.002, 0.02 and 0.2/s). All flow curves showed a peak st...
متن کاملModifying Stress-Strain Curves Using Optimization and Finite Elements Simulation Methods
Modifying stress-strain curves is one of the important topics in mechanical engineering and materials science. Real stress-strain curves should be modified after necking point as stress becomes three-dimensional after creation of throat, and consequently, equivalent stress should be used instead of axial one. Also, distribution of triple stresses across throat section is not uniform anymore, an...
متن کاملOn the measurement of stress–strain curves by spherical indentation
It has been proposed that with the appropriate models, instrumented indentation test (IIT) data can be reduced to yield the uniaxial stress–strain behavior of the test material. However, very little work has been done to directly compare the results from uniaxial tension and spherical indentation experiments. In this work, indentation and uniaxial tension experiments have been performed on the ...
متن کاملTransformation induced plasticity assisted steels: stress or strain affected martensitic transformation?
Transformation induced plasticity (TRIP) assisted steels contain a small quantity of carbon enriched retained austenite, which transforms into martensite during the course of plastic deformation. Transformation of this kind can be induced by both stress and plastic strain. The detailed mechanism by which the martensite is induced is different for these two scenarios. An attempt is made here to ...
متن کاملInfluence of High Strain Rates on the Mechanical Behavior of High-Manganese Steels
In this work, dynamic mechanical properties of three high-manganese steels with TRIP/TWIP or fully TWIP characteristics are studied. High strain rate experiments in the range of true strain rates between ~500 and 1800 /s are conducted using a dynamic torsional testing setup. All the three steels show a positive strain rate sensitivity in the intermediate range of strain rates (up to 500 /s). Bu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 2014
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane.100.1191