Stress-strain state of damaged reinforced concrete bended elements at operational load level

نویسندگان

چکیده

Abstract Each structure is exposed to different influences during operation. As a result, there are various defects and damages of these elements that affect their safe The article presents the results experimental studies reinforced concrete beams with stretched reinforcement made without initial load application. were accepted one or five Ø5.6 mm holes. In case, damage was until beam destruction (up 8.4 opening) Control samples both series destroyed due crushing compressed zone concrete. Samples damaged loading collapsed rupture reinforcement. same type failure identified for at operational level.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

FRP Repair of Corrosion-Damaged Reinforced Concrete Beams

Corrosion of steel reinforcement is one of the main durability problems facing reinforced concrete infrastructures worldwide. This paper will summarize the results of a multi-phase experimental program undertaken at the University of Waterloo to investigate the viability of using externally bonded fiber reinforced polymer (FRP) laminates to rehabilitate corrosion-damaged reinforced concrete bea...

متن کامل

Residual strength of blast damaged reinforced concrete columns

Columns are the key load-bearing elements in frame structures and exterior columns are probably the most vulnerable structural components to terrorist attacks. Column failure is normally the primary cause of progressive failure in frame structures. A high-fidelity physicsbased computer program, LS-DYNA was utilized in this study to provide numerical simulations of the dynamic responses and resi...

متن کامل

Information modeling of earthquake-damaged reinforced concrete structures

Accurate and reliable information about buildings can greatly improve post-earthquake responses, such as search and rescue, repair and recovery. Building Information Modeling (BIM), rapid scanning and other assessment technologies offer the opportunity not only to retrieve as-built information but also to compile as-damaged models. This research proposes an information model to facilitate the d...

متن کامل

Pullout Load Analysis of Reinforced Concrete Anchor Shafts

In this paper, results obtained in both conventional and finite element analysis of straight and belled anchor shafts subjected to a pullout force are presented. In numerical analysis, it is assumed that no drainage takes place during the anchor pullout. Comparisons between two conventional methods of analysis for ultimate pullout load and the results obtained by the finite element analysis are...

متن کامل

Calibration of Load and Resistance Factors for Reinforced Concrete

Current approach for designing of reinforced concrete members is based on the load and resistance factor. However the load and resistance parameters are random variables, the constant values have been designated for them in the designing procedure. Assuming these factors as the constants, will be led to the unsafe and uneconomical designs. Safe designing of structures requires appropriate recog...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Production Engineering Archives

سال: 2021

ISSN: ['2353-5156', '2353-7779']

DOI: https://doi.org/10.30657/pea.2021.27.32