Structural and luminescence characterization of β-Ga2O3 nanopowders obtained via high-energy ball milling

Defects and Structural Analysis of Multi-Wall Carbon Nano Tubes via Ball milling and Cryo-milling

Nano fillers are part of new studies to enhance various properties of fluids and solids. For example, adding nanoparticles as an enforcement in nanocomposites or as an additive to improve thermal or electrical properties in nano-fluids are of extreme importance in science and industry. There are numerous methods to uniformly disperse nanoparticles in fluid and solid phase. One of the well-used ...

defects and structural analysis of multi-wall carbon nano tubes via ball milling and cryo-milling

nano fillers are part of new studies to enhance various properties of fluids and solids. for example, adding nanoparticles as an enforcement in nanocomposites or as an additive to improve thermal or electrical properties in nano-fluids are of extreme importance in science and industry. there are numerous methods to uniformly disperse nanoparticles in fluid and solid phase. one of the well-used ...

Study of structure and luminescence of CdSe Nanocrystals obtained by ball milling

Effects of Processing Parameters on the Synthesis of (K0.5Na0.5)NbO3 Nanopowders by Reactive High-Energy Ball Milling Method

The effects of ball milling parameters, namely, the ball-to-powder mass ratio and milling speed, on the synthesis of (K0.5Na0.5)NbO3 nanopowders by high-energy ball milling method from a stoichiometric mixture containing Na2CO3, K2CO3, and Nb2O5 were investigated in this paper. The results indicated that the single crystalline phase of (K0.5Na0.5)NbO3 was received in as-milled samples synthesiz...

The Influence of Heat Treatment and High Energy Ball Milling on the Density, Hardness, and Wear Behavior of Al 7150 Alloy via Hot Uniaxial Compaction

The effect of the milling time & ageing on the hardness, density, and wear characteristics of Al 7150 alloy specimens made via powder metallurgy has been studied. The different constituents of Al 7150 alloy were processed in a planetary ball milling set up with a BPR of 10:1 for 5 hours, 10 hours, and 20 hours. At 400 °C, the milled powders were subsequently hot compacted in a punch die setup. ...