Structural dynamic analysis of turbine blade
نویسندگان
چکیده
منابع مشابه
Structural Analysis of a Composite Wind Turbine Blade
The design of an optimised horizontal axis 5-meterlong wind turbine rotor blade in according with IEC 61400-2 standard is a research and development project in order to fulfil the requirements of high efficiency of torque from wind production and to optimise the structural components to the lightest and strongest way possible. For this purpose, a research study is presented here by focusing on ...
متن کاملDynamic Response of Flexible Wind Turbine Blade
Aiming at the non-stationary and stall flutter problems of wind turbine blade caused by transient load fluctuations, the dynamic properties of wind turbine were studied, the blade was simplify to a cantilever beam in case of the action of shear deformation and cross section rotating effect were considered in this analysis, equations of the blade were established based on D'Alemberts' principle ...
متن کاملMetallurgical fatigue failure analysis of the brazed steam turbine blade
In this paper, failure mechanism of a 17th stage blade of an 82.5 MW steam turbine that caused damage to the internal turbine compartment and the adjacent blade equipment has been studied. In order to determine the cause of failure and prevent similar events, various metallurgical and mechanical investigations including chemical composition analysis, metallography and microstructural analysis, ...
متن کاملMetallurgical fatigue failure analysis of the brazed steam turbine blade
In this paper, failure mechanism of a 17th stage blade of an 82.5 MW steam turbine that caused damage to the internal turbine compartment and the adjacent blade equipment has been studied. In order to determine the cause of failure and prevent similar events, various metallurgical and mechanical investigations including chemical composition analysis, metallography and microstructural analysis, ...
متن کاملAnalysis of the Fracture of a Turbine Blade
The cause of crack initiation turbine blade had initially cracked by a fatigue mechanism over a period of time and then fractured by the overload at the last moment. Experimental procedure consists of macroscopic inspection, material verification, microscopic examination, and metallographic analysis and finally FE. And for these procedures, some specimens were prepared from a fractured blade. Us...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2017
ISSN: 1757-8981,1757-899X
DOI: 10.1088/1757-899x/247/1/012007