STRUCTURAL MORPHOGENESIS FOR FREE-SURFACE GRID SHELL WITH MEMBER OF UNIFORM LENGTH AND JOINT ANGLE
نویسندگان
چکیده
منابع مشابه
Presentation and Analysis of Methods for Increasing Glue Joint Strength in the Same Length Joint
Glue joints are more useful in Aerospace so in this article we presented new method for glue joint. In this method the maximum stresses that occurs at the edges of the bottom glue joint and cause ultimate failure in this type of connection is Decrease and increase the glue joint strength. In this method glue in the area overlapping the discrete and separate column considered Also, the connectio...
متن کاملPARALIND-based Blind Joint Angle and Delay Estimation for Multipath Signals with Uniform Linear Array
A novel joint angle and delay estimation (JADE) algorithm for multipath signals, based on the PARAllel profiles with LINear Dependencies (PARALIND) model, is proposed. Capitalizing on the structure property of Vandermonde matrices, PARALIND model is proved to be unique. Angle and delay of multiple rays of sources can be estimated by PARALIND decomposition and an ESPRIT-like shift-invariance tec...
متن کاملArc Length Based Grid Distribution For Surface and Volume Grids
Techniques are presented for distributing grid points on parametric surfaces and in volumes according to a speci ed distribution of arc length. Interpolation techniques are introduced which permit a given distribution of grid points on the edges of a three-dimensional grid block to be propagated through the surface and volume grids. Examples demonstrate how these methods can be used to improve ...
متن کاملpreparation and characterization of new co-fe and fe-mn nano catalysts using resol phenolic resin and response surface methodology study for fischer-tropsch synthesis
کاتالیزورهای co-fe-resol/sio2و fe-mn-resol/sio2 با استفاده از روش ساده و ارزان قیمت همرسوبی تهیه شدند. از رزین پلیمری resol در فرآیند تهیه کاتالیزور استفاده شد.
Surface EMG force modeling with joint angle based calibration.
In this paper, a calibration method to compensate for changes in SEMG amplitude with joint angle is introduced. Calibration factors were derived from constant amplitude surface electromyogram (SEMG) recordings from the biceps brachii (during elbow flexion) and the triceps brachii (during elbow extension) across seven elbow joint angles. SEMG data were then recorded from the elbow flexors (bicep...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Structural and Construction Engineering (Transactions of AIJ)
سال: 2016
ISSN: 1340-4202,1881-8153
DOI: 10.3130/aijs.81.565