Structural Optimization Post-Process Using Taguchi Method
نویسندگان
چکیده
منابع مشابه
Optimization of Edm Process Parameters Using Taguchi Method: a Review
Electrical discharge machining is assessed on the basis of Material Removal Rate (MRR), Tool Wear Rate (TWR), and Surface Roughness (SR). Process parameters that mostly affected the EDM Process are Pulse on Time, Pulse off Time, Discharge Current, Arc Gap and Duty Cycle. This paper reviews research for the optimization and improvement of various performance parameters measured in the experiment...
متن کاملParametric optimization of cylindrical grinding process through hybrid Taguchi method and RSM approach using genetic algorithm
The present investigation proposes a hybrid technique: Taguchi method, response surface methodology (RSM) and genetic algorithm (GA), to analyze, model and predict vibration and surface roughness in traverse cut cylindrical grinding of aluminum alloy. Experiments have been conducted as per L9 orthogonal array of Taguchi methodology using several levels of the grinding parameters. Analysis of va...
متن کاملTaguchi Design optimization using multivariate process capability index
The Taguchi method is a useful technique to improve the performance of products or processes at a lower cost and in less time. This procedure can be categorized in the static and dynamic quality characteristics. The optimization of multiple responses has received increasing attention over the last few years in many manufacturing organizations. Several approaches dealing with multiple static q...
متن کاملSoftware Quality Enhancement Through Software Process Optimization Using Taguchi Methods
This paper presents a methodology for selection of optimal softu’are design parameters using the experimental design. When an organization is at the point of taking up a new project with an objective of improving the software quality, Taguchi method is appliedfor the software design process with an objective that not more than one error is found per software module. The strategy in robust desig...
متن کاملOptimization of WEDM Process Parameters on Titanium Alloy Using Taguchi Method
This paper describes an optimum cutting parameters for Titanium Grade5 (Ti-6Al-4V) using Wire-cut Electrical Machining Process (WEDM). The response of Volume Material Removal Rate (MRR) and Surface Roughness (Ra) are considered for improving the machining efficiency. A brass wire of 0.25mm diameter was applied as tool electrode to cut the specimen. The Experimentation has been done by using Tag...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME international journal. Ser. A, Mechanics and material engineering
سال: 1994
ISSN: 1340-8046
DOI: 10.1299/jsmea1993.37.2_166