Structural phase transitions during annealing of proton-exchanged layers in X-cut and Z-cut lithium niobate
نویسندگان
چکیده
منابع مشابه
Optimized Digital Optical Switch Using Proton Exchanged Lithium Niobate Waveguides
The main emphasis in developing DOS has been on achieving low crosstalk (CT). CT in the order of -30 dB is acceptable in conventional DOS and below that value is hard to achieve. Relatively low drive voltage (or power requirements) is also necessary to optimized DOS. This paper depicts the design of Y-branched digital optical switches (DOS) with optimized on-chip area coverage, reduced driving ...
متن کاملPolarization-dependent methanol adsorption on lithium niobate Z-cut surfaces
The adsorption of single methanol molecules on the lithium niobate (0001) surface, commonly referred to as Z-cut, is investigated using first-principles calculations. It is found that the binding energy for molecular adsorption on the negative surface (∼1 eV) is about twice as large as for the positive surface. This difference is related to different bond strengths rather than electrostatics. D...
متن کاملPlasma etching of proton-exchanged lithium niobate
Plasma etching of lithium niobate with fluorine gases is limited by the redeposition LiF. This results in a low etch rate and nonvertically etched walls. Etching of proton-exchanged lithium niobate can prevent the LiF deposition to a large extent because of the greatly reduced lithium concentration in lithium niobate. We performed different inductively coupled plasma etching processes using SF6...
متن کاملFull-Wave Comparison of Z-cut and X-cut Lithium Niobate (LiNbO3) Electrooptic Modulators Using Finite Element Method
In this study we compare the relative merits of Z-cut and X-cut lithium niobate (LN) electrooptic modulators. The finite element method (FEM) has been used to implement a full wave analysis of the two structures and determine the microwave effective index Nm, the characteristic impedance Zc, the microwave losses αc and the half wave voltage VπL, operating at frequency range from 0.1 to 100GHz. ...
متن کاملAnisotropic model for the fabrication of annealed and reverse proton exchanged waveguides in congruent lithium niobate.
An anisotropic model for the fabrication of annealed and reverse proton exchange waveguides in lithium niobate is presented. We characterized the anisotropic diffusion properties of proton exchange, annealing and reverse proton exchange in Z-cut and X-cut substrates using planar waveguides. Using this model we fabricated high quality channel waveguides with propagation losses as low as 0.086 dB...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Ferroelectrics
سال: 2019
ISSN: 0015-0193,1563-5112
DOI: 10.1080/00150193.2019.1574651