Structural response of stainless steel oval hollow section compression members
نویسندگان
چکیده
منابع مشابه
Structural behavior of cold-formed stainless steel bolted connections
This paper presents a series of tests on cold-formed stainless steel bolted connections. The test specimens were fabricated from three different types of stainless steel, including austenitic stainless steel EN1.4301 (AISI 304) and EN1.4571 (AISI 316Ti having small amount of titanium) as well as lean duplex stainless steel EN1.4162 (AISI S32101). The material properties of the three types of st...
متن کاملTorsion response of a cracked stainless steel shaft
A B S T R A C T Pump shafts used for power generation are susceptible to fatigue cracking while often in near-continuous operation. Technology based on torsional vibration is under development for condition-based assessment of shaft health. The focus of this paper is on the relationship between a crack, which propagated due to bending loads, and the torsional stiffness of the shaft. An analytic...
متن کاملStainless Steel Type 316Ti
Allegheny Ludlum Type 316Ti (UNS S31635) is a titanium stabilized version of Type 316 molybdenum-bearing austenitic stainless steel. It is also known as DIN/EN designation No. 1.4571. The Type 316 alloys are more resistant to general corrosion and pitting/crevice corrosion than the conventional chromium-nickel austenitic stainless steels such as Type 304. They also offer higher creep, stress-ru...
متن کاملPreparation of Porous Stainless Steel Hollow-Fibers through Multi-Modal Particle Size Sintering towards Pore Engineering
The sintering of metal powders is an efficient and versatile technique to fabricate porous metal elements such as filters, diffusers, and membranes. Neck formation between particles is, however, critical to tune the porosity and optimize mass transfer in order to minimize the densification process. In this work, macro-porous stainless steel (SS) hollow-fibers (HFs) were fabricated by the extrus...
متن کاملDynamic recrystallization kinetics of AISI 403 stainless steel using hot compression test
In this work dynamic recrystallization behavior of AISI 403 martensitic stainless steel was studied using hot compression tests over temperature range of 900 C -1200 C and strain rate range of 0.001 s-1 - 1 s-1. The obtained flow curves showed that the hot compression behavior of the alloy is controlled by dynamic recrystallization. The flow stress and strain corresponding to the critical, pe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Engineering Structures
سال: 2009
ISSN: 0141-0296
DOI: 10.1016/j.engstruct.2008.12.002