Structural Safety Evaluation of Marine Loading Arm Using Finite Element Analysis
نویسندگان
چکیده
منابع مشابه
Appropriate Loading Techniques in Finite Element Analysis of Underground Structures
Stability of underground structures is assessed by comparing rock strength with induced stresses resulted from ground stresses. Rock mass surrounding the opening may fail either by fracture or excessive deformation caused. Accurate calculation of induced stresses is therefore fundamental in the stability analysis of an opening. Although numerical methods, particularly finite element method, are...
متن کاملFinite Element Analysis of Safety Mechanism in a Mechanical Controller
In this study, dynamic behavior of safety mechanism of a mechanical controller is investigated using 3D-FE simulation. This paper is concentrated on controller of a high acceleration projectile. The controller is located in the top of the projectile. Safety mechanism is divided to deformable and rigid parts. Deformable and rigid parts are simulated in Abaqus and Adams commercial soft wares; res...
متن کاملFinite Element Analysis for CFST Columns under Blast Loading
The columns of frame structures are the key load-bearing components and the exterior columns are susceptible to attack in terrorist blasts. When subjected to blast loads, the columns would suffer a loss of bearing capacity to a certain extent due to the damage imparted which may lead to their collapse and even cause the progressive collapse of the whole structure . The concrete-filled steel col...
متن کاملPerformance evaluation of modified bentlegPlow using finite element approach
ABSTRACT-This paper aims to develop a new design of a bentleg (BL) plow and to determine its performance as compared to the conventional one using finite element approach. The difference between the modified and conventional BL plows is the direction of angle between the projection of cutting blade on horizontal plane normal to plow shank and the line perpendicular to the plow shank in the same...
متن کاملAnalysis of Roll Wear in Reshaping Using Finite Element Simulation
Reshaping process is a widely used method for producing tubes with non-circular cross sections. Owing to the friction between pipe and rolls, initial round pipe moves forward and consequently, it gradually formed into square or rectangular one. In practice, geometric profile of the rolls will be changed after a while. These changes would be detrimental the production of faultless products. Ther...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Ocean Engineering and Technology
سال: 2013
ISSN: 1225-0767
DOI: 10.5574/ksoe.2013.27.1.043