Studies of the influence of minimum quantity lubrication MQL application on cutting forces and chip form in aluminum matrix composites machining with coated inserts

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Minimum Quantity Lubrication (MQL) in Machining: Benefits and Drawbacks

Micro lubrication or also known as minimum quantity lubrication (MQL) serves as an alternative to flood cooling by reducing the volume of cutting fluid used in the machining process; but not without significant health concerns. Flood cooling is primarily used to cool and lubricate the cutting tool and work piece interface during machining process. The adverse health effects caused by the use of...

متن کامل

Characterization of Cutting Parameters in the Minimum Quantity Lubricant (MQL) Machining Process of a Gearbox

This paper aims to find the key process parameters for machining different parts of an automobile gearbox, commissioned by a company that needs to replace with the MQL lubrication system their current machining process based on cutting fluids. It particularly focuses on the definition of appropriate cutting parameters for machining under the MQL condition through a statistical method of Design ...

متن کامل

Cutting Parameters in the Minimum Quantity Lubricant (mql) Machining Process of a Gearbox

Today one of the top priorities in the machining industry is to increase or retain the profit margin through cost reduction. In addition, consumers are becoming increasingly aware of the impact that the life cycle of products has on the environment, at the time of their choice. So companies are required to research and develop sustainable processes or adapt existing ones. This research has been...

متن کامل

Prediction of cutting forces in machining of metal matrix composites

This paper presents a mechanics model for predicting the forces of cutting aluminum-based SiC/Al2O3 particle reinforced MMCs. The force generation mechanism was considered to be due to three factors: (a) the chip formation force, (b) the ploughing force, and (c) the particle fracture force. The chip formation force was obtained by using Merchant’s analysis but those due to matrix ploughing defo...

متن کامل

Towards sustainable machining of 17-4 PH stainless steel using hybrid MQL-hot turning process

The use of a minimum quantity of lubrication (MQL) with extremely low consumption of lubricant in machining processes has been reported as a technologically and environmentally feasible alternative to conventional flood cooling. In hot machining, the external heat source is applied during machining that will assist to increase machining performance. Many external heating techniques are availabl...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Mechanik

سال: 2015

ISSN: 0025-6552

DOI: 10.17814/mechanik.2015.8-9.439