Studies on the Wire Drawing Conditions
نویسندگان
چکیده
منابع مشابه
Lawd – Laser Assisted Wire Drawing
In conventional wire drawing the diameter of a wire or rod-like workpiece is reduced by drawing it through a conical die. Dieless drawing of a wire or a rod is realized by a localized heating of the work piece. As heat source for example an induction coil can be used. Immediately after having passed the heating zone the work piece is cooled to restrict the heat input on very small region. By ap...
متن کاملthe effect of taftan pozzolan on the compressive strength of concrete in the environmental conditions of oman sea (chabahar port)
cement is an essential ingredient in the concrete buildings. for production of cement considerable amount of fossil fuel and electrical energy is consumed. on the other hand for generating one tone of portland cement, nearly one ton of carbon dioxide is released. it shows that 7 percent of the total released carbon dioxide in the world relates to the cement industry. considering ecological issu...
Influence of an Inclusion on Multi-Pass Copper Shaped-Wire Drawing by 2D Finite Element Analysis
The size and length effects of an inclusion on multi-pass copper shaped-wire drawing were investigated. For this purpose, an experimental investigation on optimal die half-angle was conducted. Based on experimental data of optimal die half-angle, wire and inclusion deformations, drawing and hydrostatic stress of copper shaped-wires that contain an inclusion were calculated by two-dimensional fi...
متن کاملExperimental studies on graph drawing algorithms
1Center for Geometric Computing, Department of Computer Science, Brown University, 115 Waterman Street, Providence, RI 02912-1910, U.S.A. 2Dipartimento di Informatica e Automazione, Università degli Studi di Roma Tre, Via della Vasca Navale 79, 00146 Roma, Italy 3Department of Computer Science and Engineering, State University of New York at Buffalo, 226 Bell Hall, Buffalo, NY 14260-2000, U.S.A...
متن کاملAdvances in wire drawing process by theoretical and numerical analysis
Ductile metal deformation processes aimed at production of wire of some sort are in use since over five thousand years, early ones dating back to the origins of copper and gold produc tion. Thin sheets, initially produced by hammering, were cut into thin strips suitable for ornamental pur poses. The introduction of die plate paved the way to round wire manufac turing, rather severe limitatio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Precision Engineering
سال: 1952
ISSN: 0374-3543
DOI: 10.2493/jjspe1933.18.321