Studies on Vibration Hand Protectors in Low Frequency Region
نویسندگان
چکیده
منابع مشابه
New frequency weighting of hand-arm vibration.
A new frequency weighting method to assess hand-arm vibration exposure is proposed in this paper. The influence of frequency components was first estimated using the method of multivariate analysis, then a simple form of the weighting curve was introduced. Compared with the frequency weighting in the current ISO 5349-1 (2001), the proposed weighting can better explain the relationship between r...
متن کاملHand-arm Frequency-weighted Vibration Effects on Tactility
This study reports results of an investigation into the short-term effects of power hand tool vibration on deep sense tactile sensitivity. Five subjects operated a simulated hand tool using a 30 s / 30 s work~rest duty cycle. The handle vibrated at 1S0 5349 weighted acceleration of 8 m / s 2, for frequencies of 20 Hz, 80 Hz, and 160 Hz, in three orthognal directions. A no-vibration condition wa...
متن کاملEffect of low-frequency vibration on workpiece in EDM processes
High-frequency vibration aided EDM has become one of the ways to increase material removal rate in EDM process, due to the flushing effect caused by vibration. However, utilizing high-frequency vibration, especially in ultrasonic range consumes a lot of setup cost. This work presents an attempt to use a low-frequency vibration on workpiece of stainless steel (SS 304) during EDM process. The wor...
متن کاملPerformance of Air Foam Flooding under Low Frequency Vibration
Foam injection is widely applied in amounts of fields to drilling, production, and formation protection. Sometimes, the application result is disappointing, which is caused by the failure of bubble generation in foam flooding. Therefore, it is necessary to seek ways for improving the performance of foam injection. An increased disturbance to the stratum, like the vibration caused by a seismic o...
متن کاملMeasurement and Analysis of Low Frequency Vibration
Low frequency vibration occurs especially in ground transportation, either as a cause in adjacent environment or within the vehicle itself. The piezoelectric accelerometers commonly used for vibration measurement are not suitable, hence other sensors capable of measuring accelerations down to sub-hertz region have to be used. Based on some previous experience with MEMS acceleration sensors a th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Sangyo Igaku
سال: 1965
ISSN: 0047-1879,1881-1302
DOI: 10.1539/joh1959.7.4_212_1