Study of hyperbranched polymer on POM-based binder in metal injection molding
نویسندگان
چکیده
منابع مشابه
study of hash functions based on chaotic maps
توابع درهم نقش بسیار مهم در سیستم های رمزنگاری و پروتکل های امنیتی دارند. در سیستم های رمزنگاری برای دستیابی به احراز درستی و اصالت داده دو روش مورد استفاده قرار می گیرند که عبارتند از توابع رمزنگاری کلیددار و توابع درهم ساز. توابع درهم ساز، توابعی هستند که هر متن با طول دلخواه را به دنباله ای با طول ثابت تبدیل می کنند. از جمله پرکاربردترین و معروف ترین توابع درهم می توان توابع درهم ساز md4, md...
Progress in Titanium Metal Powder Injection Molding
Metal powder injection molding is a shaping technology that has achieved solid scientific underpinnings. It is from this science base that recent progress has occurred in titanium powder injection molding. Much of the progress awaited development of the required particles with specific characteristics of particle size, particle shape, and purity. The production of titanium components by injecti...
متن کاملImage Analysis Dedicated to Polymer Injection Molding
This work follows the general framework of polymer injection moulding simulation whose objectives are the mastering of the injection moulding process. The models of numerical simulation make it possible to predict the propagation of the molten polymer during the filling phase from the positioning of one point of injection or more. The objective of this paper is to propose a particular way to op...
متن کاملSimulation and Injection Molding of Ring-Shaped Polymer Bonded Nickel Braze Metal Composite Preforms Based on Rheological and Thermal Analyses
Rheological and thermal properties of LD-PE and LD-PE + 65 vol% Ni composite were examined by viscosity, pvt and thermal conductivity measurements at a wide range of shear rate, temperature and pressure. The typical shear-thinning viscosity of LD-PE polymer melt was enhanced up to four times by adding 65 vol% Ni braze metal particles. LD-PE show increasing specific volume versus temperature, de...
متن کاملWax-based binder for low-pressure injection molding and the robust production of ceramic parts
In this paper, a wax-based binder was developed for low-pressure injection molding of very fine (0,4 μm) average particle size alumina ceramic bodies. The major component used in the binder mixture was paraffin wax. The process of binder removal from the green ceramics presented several difficulties especially when the ceramic powder was very fine, and the pieces had large cross-section. The pr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Research Express
سال: 2020
ISSN: 2053-1591
DOI: 10.1088/2053-1591/ab79d0