Study on the Bending Fatigue Strength of Gears : 3rd Report, Bending Fatigue Properties of Shot-Peened Gears
نویسندگان
چکیده
منابع مشابه
Bending strength simulation of asymmetric involute tooth gears
In order to enhance the load capacity of gears, researchers take notice in the asymmetric tooth gears. Asymmetric gear which has higher pressure angle of back tooth aiming to improve banding strength has been analyzed (Deng, et al., 2003). Brown et al. (Brown, et al., 2010) investigate the asymmetric tooth from both point of view of bending and scuffing. Kruger et al. (Kruger et al., 2013) anal...
متن کاملInvestigation of Metal Stiffeners in FRP Composite Gears for Increasing Tooth Bending Strength
Gears are an integral and necessary component in our everyday lives. Most of the work performed in plastic and metal but very few works available in combine effect of plastic and metal gears. The main problem while referring plastic gear is the bending strength and in case of metal gear is cost. Hence, the work is performed on metal plastic composite gear to get benefit of both. Here use the co...
متن کاملThe test analysis of transmission gears’ fatigue pitting
There were severe pitting corrosions on the surface of transmission gears in diesels. The cause of metal fatigue pitting of gear surface is analyzed in the paper, which based on the contact fatigue experiment of 18Cr2Ni4WA carburizing and quenching gears used in the diesel engine. Causes of pitting on harden tooth surface are studied from three aspects: gear surface residual stress field, oil f...
متن کاملBending Fatigue Failures of Compressor Valve Reeds
Bending fatigue failures OI cantilever type suction valve reeds occurred under operating conditions in a semi-hermetic refrigerant compressor during field trials. The finite element method (FEM) was applied to predict both the static and dynamic displacements and the resultant stresses of the reeds. The dynamic stresses in the location of the fracture exceeded the fatigue limit of the reed stee...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1966
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.32.148