Study on tool life in grinding. Studies on wafer rotation grinding method. (3rd report).
نویسندگان
چکیده
منابع مشابه
Fundamental Study on Cross Axis Grinding Method
In this study, it is experimentally investigated that the surface generation process in the cross axis grinding method with small diameter grinding wheel. In this grinding method, workpiece surface speed and sum of both wheel working surface speed and wheel feed rate crossed each other. Therefore, it is the largest characteristic that the cross angle, which is defined as the angle between the w...
متن کاملStudy on On-line Monitoring Method for Grinding Quality
A on-line monitoring new method for grinding quality is presented based on theory analysis and test study, which collects the information of grinding quality from the AE signals produced by friction and grinding process to realize the on-line intelligent detection and prediction of grinding quality by A wavelet neural network & Fuzzy BP algorithm based network. The reliability and feasibility o...
متن کاملStudy of Traverse Grinding Process (1st Report) Accumulation Phenomenon and Size Generation Mechanism in Traverse Grinding
plicated processes on the wheel surf ace along the wheel width. In order to make these processes clear, the experimental analysis of traverse grinding was conducted by widely changing the speed ratio, Kv, the setting depth of wheel, ‡TMT, and the number of total steps, m, (the ratio of the wheel width over the traverse feed per one revolution of the workpiece). The following results were obtain...
متن کاملLectures on Bubblemint and Grinding
In these talks I would like to sketch the core conceptual vocabulary of an approach to grammatical theory that has been developed in a number of unpublished papers and lectures over the past few years, and which is rather promising, in my opinion. My purpose here is not to give a final and complete presentation of the theory, but rather to pull together what seem to me to be the most promising ...
متن کاملInvestigations of silicon wafer grinding using finite element analysis
Silicon wafers are used as substrates to build more than 90% of integrated circuits. One of the manufacturing processes for silicon wafers is grinding. This paper reports the investigations of silicon wafer grinding using Finite Element Analysis (FEA). FEA models are first used to study the effects of process parameters on waviness reduction in the grinding of wire-sawn wafers on a rigid chuck....
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1987
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.53.1945